Whirlpool SF265LXTT Installation Instructions - Page 13

/ / / / / / / To Convert Gas Pressure Regulator 1. Turn the manual shutoff valve to the closed position. Unplug range or disconnect power. JJ_ ........S.... A. Lock screw B. Orifice hood Replace oven racks in oven cavity, Insert storage drawer or warming drawer into slide rails on sides of drawer opening. Lift front of drawer slightly and push firmly to close drawer. A. Torange B. Manual shutoff valve "closed" position C. Gassupply line Remove storage drawer or warming drawer. Locate gas pressure regulator at rear of storage or warming drawer compartment. NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator. 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition, operation, and burner flame adjustments, IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop, bake and broil burner flame is very important, The small inner cone should have a very distinct blue flame 1/4"(0,64 cm) to 1/2"(1.3 cm) long, The outer cone is not as distinct as the inner cone, LP gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. Gas pressure regulator 3. Remove plastic cover from gas pressure regulator cap. 4. Turn gas pressure regulator cap counterclockwise with a %" combination wrench to remove. NOTE: Do not remove the spring beneath the cap. Side view before A E / Tip Over Hazard A child or aduBt can tip the range and be killed, Connect antFtip bracket to rear range foot, Reconnect the antFtip bracket, if the range is moved, Failure to felmow these instructions can result in death or serious burns to cbimdren and adumte, C Side view after A. Plastic cover B. Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out D. Washer E. Gas pressure regulator cap 5. Turn over the gas pressure regulator cap and reinstall on regulator so that the solid end faces out and the marking "