Whirlpool WDTA50SAHV Use & Care Guide - Page 9

OPTION SELECTIONS OPTIONS CAN BE WHAT IT DOES ADDED SELECTED TIME TO WITH CYCLE (varies by model) Runs dishwasher at a later time. Select a wash cycle and options. Each time you press the Delay keypad, it will display the next available delay time. Press DELAY. Press the START/RESUME keypad. Close door firmly. NOTES: ■■ The dishwasher remembers the last Delay you selected. To reset the delay time to something other than what is displayed, continue to press the Delay keypad until the desired delay time is reached. ■■ Anytime the door is opened (such as, to add a dish), Start/Resume must be pressed again to resume delay countdown. Available with Delays start of any cycle a cycle up to 24 hours. Raises main wash temperature to improve cleaning for loads containing tough, baked-on food. Sensor Heavy Normal Soak & Clean Raises the main wash temperature to 135°F (57°C). Dries dishes with heat. This option, with the use of rinse aid, will provide better drying performance. Plastic items are less likely to deform when loaded in the top rack. Use Heat Dry for optimum dry performance. Turn the Heat Dry option off for air dry. Extended Dry lengthens the time that Heat Dry is active. This option with the use of rinse aid will provide better drying performance. Sensor Heavy Normal Soak & Clean Uses heating element to speed drying times. Heat Dry option defaults to On when any cycle is selected, except for 1-Hour Wash. NA 0:05 to 0:13 0:08 to 0:46 ADDED WATER GALLONS (LITERS) NA 0 to 3.86 (0 to 14.6) 0 (location of "Sanitized" indicator varies by model) Sanitizes dishes and glassware in accordance with NSF International NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. Only sanitizing cycles have been designed to meet the requirements of the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. There is no intention, either directly or indirectly, that all cycles on a NSF/ANSI 184 certified dishwasher meet the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. At end of the cycle, the "Sanitized" indicator will glow. If your load did not properly sanitize, the indicator will flash at the end of the cycle. This can happen if the cycle is interrupted or if the water does not reach the required temperature. The light goes off when you open and close the door or press CANCEL. Sensor Heavy Normal Raises the main wash temperature to 135°F (57°C) and the final rinse temperature to 156°F (69°C). 0:05 to 1:06 0 to 3.86 (0 to 14.6) Avoids unintended use of dishwasher between cycles or cycle and option changes during a cycle. To turn on Control Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time, indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked. To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off. 9