Whirlpool WDTA50SAHV Installation Guide - Page 24
COMPLETE INSTALLATION, Power supply cord - Plug into a, grounded 3 prong outlet, Reconnect power,
View all Whirlpool WDTA50SAHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Option D: No waste disposer - with air gap Screw-type clamps Waste tee Drain trap Air gap Large drain hose clamp Rubber hose connector Drain hose COMPLETE INSTALLATION Check that the power supply wire or cord does not touch dishwasher motor or the lower part of the dishwasher tub. 1 Rubber end 2 3 1. Connect rubber end of drain hose to air gap and cut if needed. NOTE: Do not cut ribbed section. 2. Attach drain hose to air gap with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 11/2" to 2" (38 to 50 mm) screw-type clamp (not provided). 3. Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. 60. Power supply cord - Plug into a grounded 3 prong outlet Plug into a grounded 3 prong outlet. 61. Reconnect power Reconnect electrical power at the fuse box or circuit breaker box. NOTE: With the access panel off, start the dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes, unlatch door, wait 5 seconds, then open door. Check that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. 24