Whirlpool WFE775H0H Owners Manual - Page 14

Oven Light The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the off position. 2. Turn the glass bulb cover in the back of the oven counterclockwise to remove. 3. Turn bulb counterclockwise to remove from socket. To Replace: 1. Unplug range or disconnect power. 4. Replace bulb, then bulb cover by turning clockwise. 5. Plug in range or reconnect power. TROUBLESHOOTING First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.com/product_help. Contact us by mail with any questions or concerns at the address below: In the U.S.A.: Whirlpool Brand Home Appliances Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692 Please include a daytime phone number in your correspondence. Operation PROBLEM Nothing will operate Cooktop will not operate Excessive heat around cookware on cooktop POSSIBLE CAUSES Power supply cord is unplugged. ENERGY SAVE is active, and the display is blank. Household fuse is blown, or a circuit breaker is tripped. The control displays an F9 or F9 E0 error code. The control knob is not set correctly. On ceramic glass models, the oven control lockout is set. Cookware is not the proper size. Cooktop cooking results not what expected Cooktop element cycles on and off on High setting. Oven will not operate Control knob set to incorrect heat level. Range is not level. Element cycling due to a temperature limiter. Delay start is set. Control lock is on. Control is in Demo Mode. Oven temperature too high or too low Oven indicator lights flash Electronic oven control set incorrectly. Oven temperature needs adjustment. Power to range is turned on or restored. Display shows messages Power failure (display shows flashing time). Error code (display shows letter followed by number). Start needs to be pressed so a cycle can begin (display shows "PUSH" or "PSH"). SOLUTIONS Plug into a grounded outlet. Press any key on the control to display the Time of Day. See the "Electronic Oven Controls" section for more information. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. The electrical outlet in the home may be miswired. Contact a qualified electrician to verify the electrical supply. Push in knob before turning to a setting. See the control lock keypad feature in the "Feature Guide." Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ¹⁄₂" (1.3 cm) outside the cooking area. See "Cooktop Use" section. Level the range. See the Installation Instructions. This is normal operation. The element may cycle on and off to keep the cooktop from overheating. See "Cook Time" section. Press and hold START for 3 seconds to unlock. Press and hold START TIME for 10 seconds to exit Demo Mode. Demo Mode is used for display models in a showroom. See "Electronic Oven Controls" section. See "Oven Temperature Control" in the "Electronic Oven Controls" section. See "Control Display" in the "Electronic Oven Controls" section. If the indicator lights keep flashing, call for service. See cover for contact information. Clear the display. On some models, reset the clock, if needed. See "Clock" keypad feature in the "Feature Guide" section. Depending on your model, press CANCEL to clear the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for service. See cover for contact information. See the "Start" keypad feature in the "Feature Guide" section. 14