Whirlpool WFE905C0ES Use & Care Guide - Page 16
Oven Light, Troubleshooting
View all Whirlpool WFE905C0ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Oven Light The oven light is a standard 40-watt appliance bulb. Before replacing, make sure the oven and cooktop are cool and the control knobs are in the Off position. To Replace: 1. Unplug range or disconnect power. 2. Turn the glass bulb cover in the back of the oven counterclockwise to remove. 3. Turn bulb counterclockwise to remove from socket. 4. Replace bulb by turning clockwise. 5. Replace bulb cover by turning clockwise. 6. Plug in range or reconnect power. TROUBLESHOOTING First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.com/product_help. Contact us by mail with any questions or concerns at the address below: In the U.S.A.: Whirlpool Brand Home Appliances Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692 Please include a daytime phone number in your correspondence. Operation PROBLEM Nothing will operate Cooktop will not operate Excessive heat around cookware on cooktop Cooktop cooking results not what expected Oven will not operate Convection fan not working Oven temperature too high or too low Oven indicator lights flash Display shows messages POSSIBLE CAUSES Power supply cord is unplugged. Household fuse is blown or a circuit breaker is tripped. Range is in Sabbath Mode. The control knob is set incorrectly. The range is in Demo Mode. Cookware that is not the proper size. Control knob set to incorrect heat level. Range is not level. The electronic oven control was set incorrectly. Delay Start was set. The oven control lockout is set. The range is in Demo Mode. Oven door is open. Oven temperature calibration needs adjustment. Temperature has been changed to Fahrenheit or Celsius. Needs service (oven indicator lights are flashing). Power failure (display shows flashing time). Error code (display shows letter followed by number). SOLUTIONS Plug into a grounded outlet. Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. See "Sabbath Mode" section. Push in knob before turning to a setting. Demo Mode will deactivate the Warm Zone element. See "Demo Mode" in the "Electronic Oven Controls" section. Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area. See "Cooktop Use" section. Level the range. See the Installation Instructions. See "Electronic Oven Controls" section. See "Cook Time" section. See the Control Lock keypad feature in the "Feature Guide" section. Demo Mode will deactivate all heating elements. See "Demo Mode" in the "Electronic Oven Controls" section. Close oven door. See "Convection Cooking" section. See "Oven Temperature Control" in the "Electronic Oven Controls" section. See "Fahrenheit and Celsius" in the "Electronic Oven Controls" section. See "Control Display" in the "Electronic Oven Controls" section. If the indicator light(s) keeps flashing, call for service. See the "Warranty" section for contact information. Clear the display. On some models, reset the clock, if needed. See "Clock" keypad feature in the "Feature Guide" section. Press CANCEL to clear the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call for service. See the "Warranty" section for contact information. 16