Whirlpool WGT3300XQ Installation Guide - Page 20
Complete Installation, Checklist, Level Washer/dryer
View all Whirlpool WGT3300XQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Level Washer/DRYER 5. Plug into a grounded 3-prong outlet Complete Installation CHECKLIST q Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. q Check that you have all of your tools. q Dispose of/recycle all packaging materials. Keep the plastic foam for use if the washer/dryer should be transported. q Check the washer/dryer's final location. Be sure the vent is not crushed or kinked. q Check that the washer/dryer is level and front leveling feet are tight. See "Level Washer/Dryer." q Plug into a grounded 3-prong outlet. Turn on power. q Check that the water faucets are on. q Check for leaks around faucets and inlet hoses. q Remove the blue protective film on the console and any tape remaining on the washer/dryer. q Read the "Washer/Dryer Use and Care Guide." q Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. q To test the washer, measure 1/2 the normal recommended amount of detergent and pour it into the washer. Close the lid. Select HEAVY and pull out the Cycle Control knob. Allow the washer to complete one whole cycle. q To test the dryer, set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer. If the dryer will not start, check the following: • Washer/dryer is plugged into a grounded 3-prong outlet. • PUSH TO START button has been firmly pushed. • Electrical supply is connected. • Household fuses are intact and tight, or circuit breakers have not tripped. • Dryer door is closed. q When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you do not feel heat, turn off the dryer and check to see whether the gas supply line shut-off valve is open. • If the gas supply line shut-off valve is closed, open it, then repeat the 5-minute test as outlined above. • If the gas supply line shut-off valve is open, contact a qualified technician. 20