Whirlpool WRF550CDHZ Owners Manual - Page 23
Remove and Replace Freezer Drawer Front, Style 1: Bottom Release Lever
View all Whirlpool WRF550CDHZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
REPLACE DRAWER FRONT 1. Pull out the drawer glides until they are full extended. 2. Style 1: Bottom Release Lever � Push up on the lever at the bottom of the drawer glide bracket to open. Insert the drawer front bracket into the drawer glide bracket and release the lever. Style 2: Bottom Screws � Lower the loosened screws in the top of the door front into the upper notches in the drawer glide. � Align the holes in the bottom of the drawer glides. � Replace two screws removed previously and tighten all four screws. NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the screws into the notches. 3. Reconnect Wiring (if applicable) � Align the two ends of the wiring connector and push them together until you hear a click sound and feel the tabs snap into place on the connector. 4. Lift up on the drawer front to release the plastic studs from the drawer glide bracket slots as shown below. Style 1 Style 2 A. Drawer glide bracket slots A. Drawer glide bracket slots 5. Slide the drawer glides back into the freezer. Front Style 3 1. Open the freezer drawer to full extension. 2. Loosen the four screws attaching the drawer glides to the drawer front as shown below. NOTE: Loosen screws three to four turns. Keep the screws in the drawer front. � Gently pull on the wiring connection to ensure the wiring connection is completely seated. Replace the wiring cover. NOTE: The wiring connection must be complete for the drawer temperature control to operate. 4. Replace the drawer bins onto the drawer glides. Remove and Replace Freezer Drawer Front Depending on the width of your door opening, it may be necessary to remove the freezer drawer front to move the refrigerator into your home. IMPORTANT: � If the refrigerator was previously installed and you are moving it out of the home, before you begin, turn the refrigerator control Off, and unplug the refrigerator or disconnect power. Remove food and any adjustable door or utility bins from doors. � Two people may be required to remove and replace the freezer drawer Tools Needed: 1/4" hex driver REMOVE DRAWER Front Style 1 & 2 1. Open the freezer drawer to its full extension. 2. Loosen the two screws at the top, inside the drawer front (one on the left-hand side and one on the right-hand side) that fasten the drawer front to the drawer glides as shown below. 3. Remove the 2 screws at the bottom, inside the drawer front that fasten the drawer front to the drawer glides as shown below. A. Four Bracket screws 3. Lift drawer front upward and off the screws. REPLACE DRAWER Front Style 1 and 2 1. Pull out the freezer drawer glides to their full extension. 2. Holding the drawer front by its sides, align the two plastic studs, located at the bottom, inside the drawer front, with the drawer glide bracket slots. NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the studs into the slots. 23