Whirlpool WRF550CDHZ Owners Manual - Page 26
Tools Needed, IMPORTANT, Left-Hand Side Drawer Glide, Step 2 - Adjust the Drawer Fronts Side to Side
View all Whirlpool WRF550CDHZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Tools Needed: Phillips screwdriver 1. With the drawers closed, identify the drawer front that needs to be raised or lowered. 2. Open the drawer to its full extension, and remove the interior bin. 3. Locate the drawer glide brackets. � To raise the drawer front, turn adjusting screw clockwise. � To lower the drawer front, turn adjusting screw counterclockwise. Right-Hand Side Drawer Glide � To raise the drawer front, turn adjusting screw counterclockwise. � To lower the drawer front, turn adjusting screw clockwise. 6. Insert the Phillips screwdriver into tightening screw, and turn clockwise to tighten the drawer front. 7. Close the refrigerated drawer to check the alignment. Repeat steps 2 through 6 until the drawer fronts are level. Step 2 - Adjust the Drawer Fronts Side to Side IMPORTANT: Each refrigerated drawer can be adjusted side to side on both the left and right side. A. Drawer glide brackets 4. Insert the Phillips screwdriver into tightening screw and turn counterclockwise to loosen the drawer front. 1. With the drawers closed, identify the drawer that is not aligned. 2. Open the drawer to its full extension, and remove the interior bin. 3. Locate the drawer glide brackets. 4. Starting with the glide bracket closest to the vertical gap, press and hold the release lever up. With your other hand, lift the door clip from the drawer glide bracket. A. Tightening screw B. Adjusting screw 5. Insert the Phillips screwdriver into adjusting screw to adjust the drawer front. IMPORTANT: The direction you turn the adjusting screw depends on which side of the drawer you are adjusting. Left-Hand Side Drawer Glide 26 A. Drawer front clip B. Drawer glide bracket C. Release lever 5. Reposition the drawer front clip onto the drawer glide bracket in the direction you want to move the drawer front. Make sure that the glide bracket is vertically level. 6. Release the lever to lock the glide bracket into position. 7. Repeat steps 3 through 6 for the other side of the drawer front. NOTE: Adjust the clip on the top of the second glide bracket so that it is in the same position as the side you adjusted first. 8. Close the drawer and visually inspect the gap. Repeat steps 2 though 7 until the drawer fronts are aligned. FINAL STEPS 1. Replace the interior drawer bins. NOTE: The bins must be placed into the drawers correctly so that the refrigerated drawers will close and operate properly. See "Remove and Replace Drawer Fronts." 2. Close the refrigerated drawers.