Whirlpool WRF954CIHV Owners Manual - Page 12
Replace Right-Hand Refrigerator Door, Replace Left-Hand Refrigerator Door, IMPORTANT, Final Steps
View all Whirlpool WRF954CIHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3. Disconnect the wiring plug located on top of the door hinge. ■■ Grasp each side of the wiring plug. With your left thumb, press down to release the catch and pull the sections of the plug apart. NOTE: Do not remove the green ground wire. It should remain attached to the door hinge. 4. Using the TORX T25 screwdriver, remove the 2 internal screws from the top hinge and set aside. NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working. A B A. TORX T25 screws B. Ground wire (Do not remove.) 5. Lift the refrigerator door from the bottom hinge pin. The top hinge will come away with the door. NOTE: It may not be necessary to remove the bottom hinges and brake feet assemblies to move the refrigerator through a doorway. ■■ Only if necessary, use a TORX T25 screwdriver to remove the bottom hinges and brake feet screws. Replace Right-Hand Refrigerator Door 1. Set the right-hand door onto the bottom hinge pin. 2. Insert the top hinge pin into the open hole in the top of the refrigerator door. 3. Using the 3 TORX T25 screws, fasten the hinge to the cabinet. Do not tighten the screws completely. Replace Left-Hand Refrigerator Door IMPORTANT: Do not intertwine the water tubing and wiring bundles when reconnecting them. 1. Set the left-hand door onto the bottom hinge pin. 2. Using the 3 TORX T25 screws, fasten the hinge to the cabinet. Do not tighten the screws completely. 3. Reconnect the water dispenser tubing. Insert the tubing firmly into the fitting until it stops. Close the clasp around the tubing. The clasp snaps into place between the fitting and the collar. Connect blue female side with blue male side and clasp. Repeat with gray female and gray male side. 4. Reconnect the electrical wiring. ■■ Push together the 2 sections of the wiring plug. Final Steps 1. Completely tighten the 6 internal TORX T25 screws (3 on the right-hand door hinge and 3 on the left-hand door hinge). 2. Replace both top hinge covers. 12