Whirlpool WRF954CIHV Owners Manual - Page 26
Dispensing Water, IMPORTANT, To Dispense Water-Standard, To Dispense Water-Measured Fill, NOTES,
View all Whirlpool WRF954CIHV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Dispensing Water IMPORTANT: ■■ Dispense at least 1 qt (1 L) of water every week to maintain a fresh supply. ■■ If the flow of water from the dispenser decreases, it could be caused by low water pressure. ■■ With the water filter removed, dispense 1 cup (237 mL) of water. If 1 cup (237 mL) of water is dispensed in 8 seconds or less, the water pressure to the refrigerator meets the minimum requirement. ■■ If it takes longer than 8 seconds to dispense 1 cup (237 mL) of water, the water pressure to the refrigerator is lower than recommended. See the "Water Supply Requirements" and "Troubleshooting" sections for suggestions. To Dispense Water-Standard: 1. Press a sturdy glass against the water dispenser paddle. 2. Remove the glass to stop dispensing. NOTE: The Fill button does not enable standard dispensing. It only functions in Measured Fill or Favorite Fill mode. To Dispense Water-Measured Fill: Measured Fill allows you to dispense a specified amount of water with the touch of a few buttons. 1. Put a sturdy glass under water spout. Touch MEASURED FILL to activate. NOTE: The amount of water you select will be dispensed. Make sure the container can hold the entire volume. If ice is in the container, you may need to adjust your selection. 2. Touch MEASURED FILL to turn on, then touch to select 8 oz (0.2 L), 16 oz (0.5 L), or 24 oz (0.7 L). Touch the fourth time to exit Measured Fill display. 3. Touch FILL (center button) or press paddle and the selected amount of water will be dispensed. NOTES: ■■ The Measured Fill dispenser will automatically time out after 1 minute of inactivity. ■■ You can refill several glasses with the same measurement by continuing to touch FILL (center button) after each glass fill. Measured Fill options are listed in the following chart: Units Ounces 8 16 24 Cups 1 2 3 Liters 0.2 0.5 0.7 NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] per cup) are not the same size as a measuring cup (8 oz [237 mL]). You may need to recalibrate Measured Fill to underfill or to avoid unintentionally overfilling coffee cups. 4. Dispense water. NOTE: While dispensing water, the flow of water will automatically stop once the desired volume has been dispensed. ■■ Press a sturdy glass against the dispenser paddle below the water spout. OR ■■ Place the glass below the water spout and touch FILL for hands-free dispensing. 5. To pause dispensing before the selected volume has been dispensed, touch FILL a second time or touch the water dispenser paddle. Touch FILL or paddle again to resume dispensing remaining amount. NOTE: If you stop dispensing before the desired volume has been dispensed, the display will turn off after 1 minute. If you have not resumed by then, it will reset back to the original amount. 6. To select a new volume or start dispensing the same volume again, you must first finish dispensing the selected volume or turn off the Measured Fill feature (either by waiting 1 minute so it will automatically turn off, or by touching CUBED ICE or CRUSHED ICE to manually turn it off), and then select Measured Fill again. To Dispense Water-Favorite Fill: Favorite Fill allows you to dispense a preferred amount of water with the touch of a few buttons. 1. Put a sturdy glass under water spout. Touch FAVORITE FILL to activate. NOTE: The amount of water you select will be dispensed. Make sure the container can hold the entire volume. If ice is in the container, you may need to adjust your selection. 2. Touch FAVORITE FILL to turn on, then touch to select Favorite 1 or Favorite 2. Touch the third time to exit Favorite Fill display. 3. Touch FILL (center button) and the selected amount of water will be dispensed. 26