Whirlpool WRS537SIAB Use & Care Guide - Page 7

4. While holding the handle, insert the short end of the hex key into the upper hole and slightly rotate the hex key until it is engaged in the setscrew. Location Requirements WARNING 5. Using a clockwise motion, tighten the setscrew until it begins to contact the shoulder screw. 6. Repeat steps 4 and 5 to begin fastening the lower setscrew. 7. Once both setscrews have been partially tightened as outlined in the previous steps, fully tighten both the upper and lower setscrews. IMPORTANT: When the screws feel tight, tighten them an additional quarter-turn. The handle is not properly installed without this extra tightening. 8. Open the refrigerator door and close the freezer door. Repeat steps 2 through 7 to install the other handle onto the freezer door with the setscrews facing the refrigerator. 9. Save the hex key and all instructions. To Remove the Handles: 1. While holding the handle, insert the short end of the hex key into the lower setscrew hole and slightly rotate the hex key until it is engaged in the setscrew. 2. Using a counterclockwise motion, loosen the setscrew a quarter-turn at a time. 3. Repeat steps 1 and 2 for the upper setscrew. Gently pull the handle away from the door. 4. If necessary, use a Phillips screwdriver to remove the shoulder screws from the door. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can result in death, explosion, or fire. IMPORTANT: This refrigerator is designed for indoor household use only. To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.27 cm) of space on each side and at the top. Allow for 1" (2.54 cm) of space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave a 2" (5.08 cm) minimum space on each side (depending on your model) to allow the doors to swing open. 1/2" (1.27 cm) 2" (5.08 cm) NOTES: ■ This refrigerator is intended for use in a location where the temperature ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The preferred room temperature range for optimum performance, which reduces electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F (32°C). It is recommended that you do not install the refrigerator near a heat source, such as an oven or radiator. ■ Normal minimum cabinet cut-out width required for product installation is 36" (91.44 cm). However, if the product is placed against an extended wall and the ability to remove the crisper pans is desired, an additional 18" (45.72 cm) of cabinet width is required, so a total cabinet opening width of 54" (137.16 cm) is recommended. 7