Whirlpool WVU37UC4F Installation Instructions - Page 13
Warning
View all Whirlpool WVU37UC4F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Connect Vent System Connect the ventwork to the range hood. Seal joints with vent clamps or duct tape to make secure and airtight. Check that the backdraft dampers work properly. Power Supply Cable Installation 1. For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the hood electrical terminal box. For optional power supply cord kit (see the "Accessories" section), follow the instructions in the "Make Electrical Connections" section. NOTES: ■■ Use only with range hood cord connection kits that have been investigated and found acceptable for use with this model range hood. ■■ Do not reconnect power until the installation is complete. 2. Remove the screw from the terminal box cover. Remove terminal box cover and set aside. Make Electrical Connection Option 1 - Direct Wire Installations WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Disconnect power. G C D E A B A B A. Terminal box cover B. Screw F A. White wires B. Black wires C. UL Listed wire connector D. Green (or bare) ground wire E. Home power supply cable or power cord accessory kit F. UL Listed or CSA Approved ½" strain relief G. Green ground screw 2. Use UL Listed wire connectors and connect white wires (A) together. 3. Use UL Listed wire connectors and connect black wires (B) together. WARNING Fire Hazard Electrically ground the blower. Use copper wire. Connect ground wire to green ground screw in terminal box. Failure to do so can result in death, fire, or electrical shock. 4. Connect green (or bare) ground wire from power supply to green ground screw in terminal box and securely tighten. 5. Install terminal box cover. 6. Reconnect power. 13