Xerox 1235/DX Network Guide - Page 9
Windows NT 4.x Network, Introduction, Preliminary steps, Quick install steps (TCP/IP protocol)
UPC - 042215474542
View all Xerox 1235/DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Windows NT 4.x Network Introduction Your printer can be installed on a Windows NT network using one of two methods: I TCP/IP protocol I AppleTalk protocol The Preliminary Steps given below must be accomplished for all printers regardless of the protocol that is being used. Then, the Quick Install Steps will detail the installation based on the protocol used on your network. The CentreWare DP program on your Printer Management Software CD-ROM can also be used to monitor and configure the printer. Preliminary steps 1. Print the Configuration Sheet. Details are in this document in Appendix A: Print the Configuration Sheet. Retain this page for reference. 2. Check the Configuration Sheet and verify that both the desired protocol and connector are enabled. 3. Proceed to the Quick Install Steps for your network protocol. Quick install steps (TCP/IP protocol) 1. At the Desktop, right-mouse-click the Network Neighborhood icon and select Properties. 2. Click on the Protocols tab and verify that the TCP/IP protocol has been loaded. 3. Select the Services tab and verify that Microsoft TCP/IP Printing is loaded. 4. If this software is not present, install it using the documentation provided by Microsoft. Then return to this document. 5. Open the Control Panel and double-click the Printers icon. 6. Double-click Add Printer; the Add printer Wizard starts.