Xerox 3400N Service Guide - Page 2
Surgxfw
UPC - 095205114874
View all Xerox 3400N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
8VHU VDIHW\ VXPPDU\ 7HUPV LQ PDQXDO CAUTION Conditions that can result in damage to the product. WARNING Conditions that can result in personal injury or loss of life. 3RZHU VRXUFH For 110 VAC printers, do not apply more than 135 Volts RMS between the supply conductors or between either supply conductor and ground. Use only the specified power cord and connector. For 220 VAC printers, do not apply more than 264 Volts RMS between the supply conductors or between either supply conductor and ground. Use only the specified power cord and connector. Refer to a qualified service technician for changes to the cord or connector. 2SHUDWLRQ RI SURGXFW Avoid electric shock by contacting a qualified service technician to replace fuses inside the product. Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of explosive gases. WARNING Turning the power off using the On/Off switch does not de-energize the printer. You must remove the power cord to disconnect the printer from the mains. Keep the power cord accessible for removal in case of an emergency. 6DIHW\ LQVWUXFWLRQV Read all installation instructions carefully before you plug the product into a power source. 7HUPV RQ SURGXFW CAUTION A personal injury hazard exists that may not be apparent. For example, a panel may cover the hazardous area. Also applies to a hazard to property including the product itself. DANGER A personal injury hazard exists in the area where you see the sign. &DUH RI SURGXFW Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any excess moisture, if product is dropped or damaged, if you suspect that the product needs servicing or repair, and whenever you clean the product. *URXQG WKH SURGXFW Plug the three-wire power cord (with grounding prong) into grounded AC outlets only. If necessary, contact a licensed electrician to install a properly grounded outlet.