Xerox 6180N DocuSP 3.6 to 3.7 Differences - Page 33
Auto End changes and moves, Save Job Setup upon exit, Image Shift support, Stock management
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
limited by the available hard disk space. The entire job must be spooled to disk before the decomposer can begin ripping. Auto End changes and moves ¨ In previous versions, the operator needed to press "Start" to start an online job and press "End" to finish the job. The operator needed to be present to press "End" so that network jobs could be scheduled and printed. ¨ The AutoEnd feature allows: ¨ Online jobs to automatically end and start based on a timer set in the Online Gateway configuration. ¨ Online jobs automatically end and start based on the receipt of the channel command 0x6b (raise cover) in the datastream. ¨ Now the AutoEnd feature invokes the "End" for the current job and starts a new job without operator intervention. ¨ The System Administrator enables AutoEnd. By default, the AutoEnd feature is disabled. ¨ AutoEnd is supported in both streaming and spooling modes. ¨ AutoEnd and AutoDrain with a timer cannot be set at the same time. Save Job Setup upon exit ¨ A popup message prompting the operator to save the current job setup will no longer display when an operator exits online manager. ¨ To save a job setup to a file, the operator will have to select the Save or Save As button in the online manager window. Image Shift support ¨ Image shift is supported for LCDS jobs on the DocuPrint 75/90 and on DocuPrint 1xx EPS printers. ¨ Image shift changes must be applied before the job is sent. Any changes made while a job is printing are not honored until the next job. ¨ If the operator shifts the image too far in a negative direction, the image may be cropped. Stock management ¨ The Aux, Main, and Auto stock definitions are available in the Stock Library and cannot be deleted from the system. DocuSP 3.6 to 3.7 Differences Document 29