Xerox C2424 User Guide Section 6: Networking - Page 26

Windows 98 and Windows Me Quick CD-ROM Install Steps 1. Insert the WorkCentre C2424 Software CD-ROM into the computer's CD-ROM drive. If the installer does not launch, do the following: a. Click Start, then click Run. b. In the Run window, type: :\INSTALL.EXE. 2. Select your desired language from the list. 3. Select Install Device Driver. 4. Click I Agree to accept the Xerox Software License Agreement. 5. In the Select Printer dialog box, the default Use Walk-Up Technology (recommended for network systems) is selected. Click Next. 6. Follow the Use Walk-Up Technology instructions displayed. 7. Click Exit Program. Note If the Walk-Up Technology dialog box remains onscreen after you have completed Steps 1-6, click the Back button, then click Select from the following discovered printers. Follow the onscreen prompts to complete the installation procedure. For more information, go to the table of infoSMART Knowledge Base documents at the end of this section. Other Methods of Installation Install your system on a Windows 98 or Windows Me network using one of these methods: ■ Xerox TCP/IP Port Monitor ■ PhaserPort Software Xerox TCP/IP Port Monitor The Windows installer installs the Xerox TCP/IP Port Monitor. The Xerox TCP/IP Port Monitor can be used to add or remove TCP/IP ports. Adding a Port 1. Open Printer Properties for the system you would like to attach to the new TCP/IP port. 2. Click Start, click Settings, then click Printers. 3. Right-click the system to be attached to the new TCP/IP port, then click Properties. 4. Click the Details tab, then click the Add Port button. 5. Select Other. 6. From the list of available printer-port monitors, select the Xerox TCP/IP Port, then click OK. WorkCentre® C2424 Copier-Printer 6-26