Yamaha 430 Owner's Manual - Page 78
Secure A., Connect the speaker cord., Attach C., shown, then clip the cord into the holders.
View all Yamaha 430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
4. Secure A. 4-1 Secure A from the rear using two short screws (6 x 16 mm). 4-2 Secure A from the rear using two thin screws (4 x 14 mm). 4-3 Secure A from the front using four short screws (6 x 16mm). 4-2 A 6. Connect the pedal cord. 6-1 Insert the pedal cord plug into the [PEDAL] connector. 6-2 Attach the cord holders to the instrument as shown, then clip the cord into the holders. At this time, be careful not to allow too much slack in the pedal cord between the plug and cord holder. 6-1 4-1 4-3 4-4 Firmly tighten the screws you temporarily fastened on B in steps 2-3 above. 4-4 5. Connect the speaker cord. 5-1 Remove the twist tie attaching the speaker cord. 5-2 Insert the speaker cord plug into the connector so that the protruding tab on the plug faces toward right when viewed from the rear. 6-2 Insert the pedal cord E securely until the metal part of the cord plug disappears from view. Otherwise, the pedal may not function properly. 7. Attach C. 7-1 Place on D, the stopper-wood in the bottom corners of C, then attach the top of C. 7-2 Secure upper right and left of C using two thin screws (4 x 14 mm). 7-3 Secure upper center and bottom of C using five tapping screws (4 x 20 mm). 7-2 7-1 D C C 7-3 5-2 78 Appendix Assembling the Clavinova