Yamaha 6 MODX 6/7/8 Owners Manual - Page 22

Setting Up Power Supply Connect the supplied AC adaptor in the following order. Before you connect the AC adaptor, make sure the [1] (Standby/On) switch on the instrument is set to the Standby (/) position. 1 Wrap the DC output cable of the AC adaptor around the cable clip (as shown below), and then connect the plug of the adaptor to the DC IN jack on the rear panel. Cable clip Be careful not to bend the connector CAUTION • When setting up the product, make sure that the AC outlet you are using is easily accessible. If some trouble or malfunction occurs, immediately turn the power off and disconnect the plug from the outlet. • The instrument remains charged and draws a small amount of power even when the [1] (Standby/On) is set to the Standby position. For this reason, if you intend not to use it for an extended period of time, make sure to unplug the power cord from the wall outlet. Connecting Speakers or Headphones Since the instrument has no built-in speakers, you will need to monitor the sound of the instrument by using external equipment. Connect a set of headphones, powered speakers, or other playback equipment as illustrated below. When making connections, be sure that your cables have the appropriate ratings. Powered speaker (left) Powered speaker (right) NOTE Use of the cable clip prevents accidental unplugging of the cable during operation. Make sure to avoid tightening the cord more than necessary or pulling on the cord strongly while it is wrapped around the cable clip to prevent wear on the cord or possible breakage of the clip. 2 Connect the other end of the AC adaptor to an AC outlet. DC IN jack (page 16) 1 AC adaptor AC outlet 2 NOTE Reverse the order of the instruction steps above when disconnecting the AC adaptor. WARNING • Use the specified AC adaptor (page 71) only. Using the wrong AC adaptor can result in damage to the instrument or overheating. • When using the AC adaptor with a removable plug, make sure to Plug keep the plug attached to the AC adaptor. Using the plug alone can cause electric shock or fire. • Never touch the metallic section when attaching the plug. To avoid electric shock, short circuit or damage, also be careful that there is no dust between the AC adaptor and plug. Slide the plug as indicated. The shape of the plug differs depending on your area. Headphones OUTPUT L/MONO OUTPUT R PHONES Powering Up the System Make sure the volume settings of the instrument and external devices such as powered speakers are turned to the minimum before turning the power on. When connecting the instrument to powered speakers, turn on the power switch of each device in the following order. When turning the power on: First, the instrument (the display will turn on and the buttons will light), then the connected powered speakers. When turning the power off: First, the connected powered speakers, then the instrument (the display will turn off and the buttons will turn off). Keep in mind that the [1] (Standby/On) switch is located at the left side (from the view of the keyboard) of the DC IN socket on the rear panel of the instrument. DC IN [1] (Standby/On) switch 18 MODX Owner's Manual