Yamaha 6 MODX 6/7/8 Owners Manual - Page 71

Troubleshooting  Are the volume or expression settings too low? [UTILITY]  [Settings]  [Sound]  Tone Generator "Volume" [EDIT]  [General]  "Volume" [EDIT]  Part selection  Element/Key/Operator [Common]  [Part Settings]  [General]  "Volume" [EDIT]  Part selection  Element/Key/Operator [Common]  [Part Settings]  [General]  "Dry Level" • In case of Normal Part (AWM2) and Drum Part [EDIT]  Part selection  Element/Key selection  [Amplitude]  [Level/Pan]  "Level" • In case of Normal Part (FM-X) [EDIT]  Part selection  Operator selection  [Level]  "Level"  Are the parameter settings such as Element Switch, Note Limit, Velocity Limit, and Velocity Offset appropriate? • In case of Normal Part (AWM2) and Drum Part [EDIT]  Part selection  Element/Key/Operator [Common]  [Part Settings]  [General] [EDIT]  Part selection  Element/Key selection  [Osc/Tune] • In case of Normal Part (FM-X) [EDIT]  Part selection  Element/Key/Operator [Common]  [Part Settings]  [General]  Is the Mute switch for each Element/Operator of Part turned on? [EDIT]  Part selection  Mute Switch of each Element/Operator  In case of Normal Part (FM-X), is the Carrier Level is set to "0"? [EDIT]  Part selection  Operator selection  [Level]  "Level"  Is the output parameter of each Part turned off? [EDIT]  Part selection  Element/Key/Operator [Common]  [Part Settings]  [General]  "Part Output" No sound from the A/D INPUT jacks.  Is the switch of the microphone turned on?  Check the microphone type. Make sure to use a dynamic microphone.  Is the cable between the microphone or audio equipment and this instrument properly connected?  Is the A/D INPUT [GAIN] knob turned to the minimum?  Is the A/D INPUT [ON/OFF] button turned on?  Check whether or not the connection status of the A/D INPUT [L/MONO]/[R] matches the "Mono/Stereo" parameter. [EDIT]  [Audio In]  [Mixing]  A/D In "Input Mode"  Check whether or not the "Mic/Line" parameter is set to the appropriate value. When the output level of the connected equipment (such as a microphone) is low, set this parameter to "Mic." When the output level of the connected equipment (such as a synthesizer keyboard, CD player) is high, set this parameter to "Line." [UTILITY]  [Settings]  [Audio I/O]  "A/D Input"  Are the volume settings of the A/D Input Part too low? [EDIT]  [Audio In]  [Mixing]  A/D In "Volume"  Are the effect settings appropriate? [EDIT]  [Audio In]  [Routing]  Is the output setting of the A/D Input Part set appropriately? [UTILITY]  [Settings]  [Audio I/O]  Output  Check whether or not the Vocoder Effect is selected. When Vocoder is selected as the Insertion Effect for the current Part, the audio signal input from the A/D INPUT [L/MONO]/[R] jacks may not produce any sound depending on the parameter settings. [EDIT]  Part selection  Element/Key/Operator [Common]  [Effect]  [Routing] 67 MODX Owner's Manual