Yamaha AS1000 Owner's Manual - Page 16

Connecting the speakers, Connecting the speakers using the, banana plug, Except for Europe models, Y

Get Yamaha AS1000 - Amplifier PDF manuals and user guides View all Yamaha AS1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Connections Caution If you use two sets (A and B), the impedance of each speaker must be 8 Ω or higher. When only using one set of speakers (A or B), use speakers with an impedance of 4 Ω or higher. ■ Connecting the speakers 1 Remove approximately 10 mm (0.4 in) of insulation from the end of each speaker cable and twist the exposed wires of the cable together to prevent short circuits. ■ Connecting the speakers using the banana plug (Except for Europe models) First, tighten the knob and then insert the banana plug into the end of the corresponding terminal. Banana plug 10 mm (0.4 in) 2 Unscrew the knob and then insert the bare wire into the hole. ■ Connecting the speakers using the Y-shaped lug 1 Unscrew the knob and then sandwich the Y-shaped lug between the ring part and base. Slide Y-shaped lug 3 Tighten the knob. 2 Tighten the knob. 16 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
16
En
Connections
If you use two sets (A and B), the impedance of each speaker
must be 8
Ω
or higher. When only using one set of speakers (A or
B), use speakers with an impedance of 4
Ω
or higher.
■
Connecting the speakers
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
2
Unscrew the knob and then insert the bare
wire into the hole.
3
Tighten the knob.
■
Connecting the speakers using the
banana plug
(Except for Europe models)
First, tighten the knob and then insert the banana
plug into the end of the corresponding terminal.
■
Connecting the speakers using the
Y-shaped lug
1
Unscrew the knob and then sandwich the
Y-shaped lug between the ring part and base.
2
Tighten the knob.
Caution
10 mm (0.4 in)
Banana plug
Y-shaped lug
Slide