Yamaha AX-396 Owner's Manual - Page 14

Sound control, Using the CD/DVD DIRECT AMP switch - amplifiers

Page 14 highlights

Ⅵ Sound control Adjusting the BALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions. BALANCE l 0l 2 2 3 3 4 L5 4 5R Using the CD/DVD DIRECT AMP switch You can enjoy the purest possible sound from your CD or DVD player by pressing this switch. The indicator above it lights up. With this function on, input signals from the CD or DVD player are sent directly to the built-in special amplifier for CD/DVD bypassing the INPUT selector, the BASS, TREBLE, BALANCE and LOUDNESS controls (and the TAPE MONITOR switch for AX-396 only), and then sent to the power amplifier. This signal routing reproduces the purest sound eliminating any alterations to the CD or DVD signals. CD/DVD DIRECT AMP Using the PURE DIRECT switch AX-496 only You can enjoy the purest possible sound from your audio sources by pressing this switch. The indicator above this switch lights up. With this function on, the audio signals bypass the BASS, TREBLE, BALANCE and LOUDNESS controls, thus eliminating any alterations to the audio signals. PURE DIRECT Adjusting the BASS and TREBLE controls BASS: BASS l 0l 2 2 3 3 4 5 4 5 TREBLE l 0l 2 2 3 3 4 5 4 5 Turn this knob clockwise to increase (or counterclockwise to decrease) the low frequency response. TREBLE: Turn this knob clockwise to increase (or counter clockwise to decrease) the high frequency response. Adjusting the continuously variable LOUDNESS control This control compensates for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. This control is adjustable to retain full tonal range at any volume level. 1 LOUDNESS l FLAT -30dB 2 I0 3 9 4 8 5 7 6 Set to the "FLAT" position. 2 l6 20 l2 28 8 Set to the loudest listening level that you would listen to. 40 4 60 2 0 -dB 3 LOUDNESS l FLAT -30dB 2 I0 3 9 Turn until the desired volume is obtained. 4 8 5 7 6 Note If both the CD/DVD DIRECT AMP and PURE DIRECT switches are on, only the CD/DVD DIRECT AMP switch will function. E-12 WARNING If the CD/DVD DIRECT AMP switch (or PURE DIRECT switch for AX-496 only) is pressed to turn it on with the LOUDNESS control set at a certain level, the sound will suddenly increase and may damage your ears or the speakers. (The LOUDNESS control function may be bypassed.) For this reason, be sure to press the CD/ DVD DIRECT AMP switch (or PURE DIRECT switch for AX-496 only) after lowering the volume or after checking that the LOUDNESS control is properly set.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17

E-
12
Adjusting the BALANCE control
Adjust the balance of the output volume to the left and right
speakers to compensate for sound imbalance caused by
speaker location or listening room conditions.
Using the CD/DVD DIRECT AMP switch
You can enjoy the purest possible sound from your CD or
DVD player by pressing this switch. The indicator above it
lights up.
With this function on, input signals from the CD or
DVD player are sent directly to the built-in special amplifier
for CD/DVD bypassing the
INPUT
selector, the
BASS,
TREBLE, BALANCE
and
LOUDNESS
controls (and the
TAPE MONITOR
switch for AX-396 only), and then sent to
the power amplifier.
This signal routing reproduces the
purest sound eliminating any alterations to the CD or DVD
signals.
Using the PURE DIRECT switch
AX-496 only
You can enjoy the purest possible sound from your audio
sources by pressing this switch.
The indicator above this
switch lights up.
With this function on, the audio signals
bypass the
BASS, TREBLE, BALANCE
and
LOUDNESS
controls, thus eliminating any alterations to the audio
signals.
Note
If both the
CD/DVD DIRECT AMP
and
PURE DIRECT
switches are on, only the
CD/DVD DIRECT AMP
switch will
function.
Adjusting the BASS and TREBLE controls
BASS:
Turn this knob clockwise to increase (or counter-
clockwise to decrease) the low frequency
response.
TREBLE:
Turn this knob clockwise to increase (or counter
clockwise to decrease) the high frequency
response.
Adjusting the continuously variable
LOUDNESS control
This control compensates for the human ears’ loss of
sensitivity to high and low-frequency ranges at low volume.
This control is adjustable to retain full tonal range at any
volume level.
1
Set to the “FLAT” position.
2
Set to the loudest listening level
that you would listen to.
3
Turn until the desired volume is
obtained.
WARNING
If the
CD/DVD DIRECT AMP
switch (or
PURE DIRECT
switch for AX-496 only) is pressed to turn it on with the
LOUDNESS
control set at a certain level, the sound will
suddenly increase and may damage your ears or the
speakers. (The
LOUDNESS
control function may be
bypassed.)
For this reason, be sure to press the
CD/
DVD DIRECT AMP
switch (or
PURE DIRECT
switch for
AX-496 only) after lowering the volume or after checking
that the
LOUDNESS
control is properly set.
m
Sound control
BALANCE
5
5
4
3
2
l
0
l
2
3
4
L
R
BASS
5
5
4
3
2
l
0
l
2
3
4
TREBLE
5
5
4
3
2
l
0
l
2
3
4
CD/DVD DIRECT AMP
PURE DIRECT
LOUDNESS
5
6
7
4
3
2
l
FLAT
I0
—30dB
9
8
l6
20
28
40
60
l2
8
4
2
0
–dB
LOUDNESS
5
6
7
4
3
2
l
FLAT
I0
—30dB
9
8