Yamaha BBT500-110 Owner's Manual - Page 13
Detailed Parameter Settings, Amp Mode
View all Yamaha BBT500-110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Detailed Parameter Settings The BBT500 also features more precise settings for defining the frequencies for each of the Tone Control knobs, operating the Compressor and Noise Gate, or setting the Blend Level of the effect loop, etc. To access these settings, press the [FUNCTION] switch and use the four Modes described below. • Amp Mode In this mode, each knob functions in the manner it is labeled on the front panel. • Equalizer Mode This mode is used to set the 1-band parametric equalizer and the center frequency for each of the Tone Controls (Bass - Treble). • Compressor Mode This mode is used to set the Compressor's blend level, noise gate level, and effect loop. • Utility Mode This mode is used to set the crossover filter, and individual MIDI settings. Individual settings in the Amp Mode, Equalizer Mode, and Compressor Mode are saved when patch data is saved to the unit's memory. Individual parameter settings in the Equalizer Mode and Compressor Mode are set to their default values when the power is switched ON. Individual settings in the Utility Mode are saved when exiting the Utility Mode, and they are retained even if the power is switched OFF. Amp Mode Each knob functions in the manner it is labeled on the panel. In the Amp Mode, the knob's value (or patch's setting value) is shown on the display when the knob is turned. * After the BBT500's power is switched ON or the [MANUAL] switch is pressed, nothing is shown in the display until a Memory is recalled, or a mode other than the Amp Mode is selected. Enter the Amp Mode using one of the following methods. • The Amp Mode is the default mode when the BBT500's power is switched ON. • Press the [MANUAL] Switch to enter the Amp Mode. • Press a Memory Switch [1] - [5] to recall a patch. Or, press and hold a Memory Switch to save a patch to memory. • In the Equalizer, Compressor, or Utility Mode, press the [FUNC- TION] switch. ● How Knobs Function in the Amp Mode The knob's value is shown on the display when the knob is turned. q w e r t y u i o !0 !1 Each control knob's function in the Amp Mode is the same as described in the "Sound Setting" section (→ pg. 11). q INPUT LEVEL: Sets the Input Level w SOUND TYPE: Selects the Sound Type (11 types) e COMP: Compression Ratio (1.0 to ∞, 16 steps) r GAIN: Pre-Amp Gain (0 to 10, 0.1 step) t MASTER: Master Volume (0 to 10, 0.1 step) y BASS: Bass Frequency (-15dB to +15dB, 0.2dB step) u LOW MID: Low Mid Frequency (-15dB to +15dB, 0.2dB step) i MIDDLE: Middle Frequency (-15dB to +15dB, 0.2dB step) o HIGH MID: High mid Frequency (-15dB to +15dB, 0.2dB step) !0 TREBLE: Treble Frequency (-15dB to +15dB, 0.2dB step) !1 OUTPUT: Sets the output level 13