Yamaha BD-A1000 Owners Manual - Page 35

■ General Setting The default settings are marked with " * ". System Screen Saver You can set the screen saver to on/off. When set to on, this Player will switch to screen saver mode if there is no operation for 3 minutes. After that, this Player will turn to standby mode when there is no operation for 6 minutes. On*, Off Disc Auto Playback You can set Disc Auto Playback to on/off. When set to on, a disc will play back automatically after loading. On*, Off HDMI Control You can set the Player to receive control signal from a TV/AV receiver compatible with the HDMI Control function via an HDMI cable (p. 12). On, Off* Using HDMI Control function Using the HDMI Control function, you can interactively operate this Player with your TV (HDMI Control function supported). When you connect this Player to the TV compatible with the HDMI Control function using an HDMI cable and set HDMI Control in the SETUP menu to on (p. 31), you can perform the function listed below. • Automatic input select function When you start playback of this Player, the input selector of the TV (and an AV receiver if this Player is connected to the TV via the AV receiver) is switched to this Player automatically. TV Power is turned on automatically depending on the TV. • Automatic power off function When you turn off the TV while this Player is in stop mode and the SETUP menu screen is not displayed, the power of this Player is also turned off automatically. Notes - HDMI Control function may not work properly depending on the TV. - Functions other than ones shown above may work depending on the TV or AV receiver. - In order to make the HDMI Control function available, set up settings for the HDMI Control function on ALL components (this Player, TV, and AV receiver). Certain operation may also be required. - Each function may be set independently to activate/deactivate depending on the TV. - Refer to the operation manuals supplied with the TV and/or AV receiver for details regarding setup. SETUP MENU Network Control You can set control via Ethernet to on/off. This player employs Yamaha Network Control protocol (YNC). On, Off* Notes - When set to on, power consumption during standby mode increases due to network control function. - When set to on, the system startup time is increased. Load Default 4 You can reset all settings of this Player to default setting except Security setting (p. 32). For details on default settings, see pages 28-35. Upgrade You can upgrade the software manually from Disc, USB Storage or Network. For details on software upgrade, refer to "SOFTWARE UPGRADE" (p. 38). Easy Setup You can perform Easy Setup (p. 18). Local Storage You can display Local Storage information, format Local Storage, and select Front USB/Rear USB to save the BDLive data. To format (empty) the BUDA folder in the USB memory device, select Information and press ENTER when "Format" is focused on the screen. Front USB, Rear USB* Local Storage It is used as an auxiliary memory when Blu-ray Disc is played back. SETTINGS English 31 En