Yamaha CLP-625 CLP-625 Owners Manual - Page 30
Keyboard Stand Assembly
View all Yamaha CLP-625 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Keyboard Stand Assembly CAUTION • Assemble the unit on a hard and flat floor with ample space. • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble the unit in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten all screws upon completing assembly of the unit. • To disassemble the unit, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. 1. Attach (finger-tighten) C to D and E. 1-3 Remove all parts from the package and make sure you have all of the items. Foamed styrol pads Remove foamed styrol pads from the package, position them on the floor, then place A on top of them. Position the pads so that they will not hide the connectors on the bottom of A. Bundled pedal cord inside Cord holder 1-1 1-1 Untie and straighten out the bundled pedal cord. 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws (6 x 20 mm). 2. Attach B. 2-1 2-2 6 x 20 mm long screws x 4 Power cord x 1 4 x 12 mm thin screws x 2 4 x 20 mm tapping screws x 4 6 x 16 mm short screws x 6 AC adaptor x 1 The power cord and adaptor may not be included, or may look different from the illustration above, depending on your particular area. Please check with your Yamaha dealer. 4 × 10 mm thin screws x 2 Headphone hanger x 1 30 CLP-625 Owner's Manual 2-3 2-2 2-2 2-1 Align the screw holes on the upper side of B with the bracket holes on D and E, then attach the upper corners of B to D and E by finger-tightening two thin screws (4 x 12 mm). 2-2 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 x 20 mm).