Yamaha CVP-305 Owner's Manual - Page 204
CVP-303: Keyboard Stand Assembly
View all Yamaha CVP-305 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
CVP-303: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of Have a Phillips-head (+) screwdriver ready. each unit. • To disassemble, reverse the assembly sequence given below. 1 Open the package, take out the pedal box, take out the styrofoam pads, and place the main unit on top of the pads. Position the pads so that they will protect the headphone jack located underneath the front left corner. Main unit Phones jacks To prevent the key cover from accidentally opening during assembly, press down on the key cover, making sure that the sheet (shown) Styrofoam pads remain in place. Remove the parts shown below from the box. Rear panel 2 Attach the side panels to the pedal box. Side panel (left) 1 Untie and straighten out the bundled cord attached to the bottom of the pedal box. Don't discard the vinyl tie, you'll need it later in step 6. Side panel (right) 2 Use the four 6x25 mm long screws to attach the pedal box. First attach one side panel, then attach the other side panel. 3 Attach the rear panel. 1 Place the bottom edges of the rear panel on the feet's protruding edges, with the panel slightly angled as shown in the illustration. Then, align the top part of the panel with the side panels. 2 Secure the top of the rear panel to the side panel brackets using two 4x12 mm thin screws. 3 Secure the bottom of the rear panel to the pedal box using four 4x20 mm tapping screws. Pedal box Bundled pedal cord inside Side panel (left) Assembly Parts 6 x 25 mm long screws x4 6 x 16 mm short screws x4 4 x 12 mm thin screws x2 Side panel (right) AC power cord 4 x 20 mm tapping screws x4 Cord holders x2 4 Mount the main unit. CAUTION • Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit. • Do not hold the keyboard in any position other than the position shown in the illustration. Be sure to place your hands at least 10 cm from either end of the main unit when positioning it. At least 10 cm Appendix 204 CVP-305/303/301 Owner's Manual