Yamaha DSP-RX-EX DSP-RX-EX DSP-RX Owners Manual - Page 14
Installing an HY Card, guide rails inside the slot, and then insert
View all Yamaha DSP-RX-EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installing an HY Card 1. Make sure that both power indicators are off. Caution Installing or removing a card while the power is on may lead to component failure or electric shock. 2. Remove the screws that fasten the slot cover to remove the slot cover. Keep the cover and fixing screws in a safe place for future use. Push the card all the way into the slot so that the connector at the end of the card is correctly inserted into the connector inside the slot. Slot cover 3. Align both edges of the HY card with the guide rails inside the slot, and then insert the card into the slot with the card installation lever pressed down. NOTE For information on which cards support each slot, refer to "Part Names and Functions" on page 11. 4. Pull up the card installation lever to lock in the card. Make sure that the lever claw is securely locked under the bottom part of the slot. NOTE If the lever claw does not lock in, pull up the card slightly, then push it in. 5. Affix the card using the screws that were previously used to affix the slot cover. If the card is not fastened securely, component failure or malfunction may occur. Card 14 DSP-RX(-EX) Owner's Manual