Yamaha DSP-RX-EX DSP-RX-EX DSP-RX Owners Manual - Page 9
Part Names & Functions, Front Panel
View all Yamaha DSP-RX-EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Part Names & Functions Front Panel LCD Indicates the setting parameters for the unit. Color Indicator Indicates the status of the unit. Green Yellow (lit steadily) Red (flashing) Normal Indicates a minor issue, but you can continue using the unit. A critical error has occurred. [MENU] key The following setting parameters are indicated on the LCD: Unit ID Fan Spd Brightns Contrast FaultOut Specifies the Unit ID for the unit. You must set a unique ID for each device connected to the same I/O network so that they will be identified correctly. For more information on setting the Unit ID, refer to "Setting the Unit ID" in the RIVAGE PM series Operation Manual. Specifies the speed of the cooling fans on the unit. This setting does not affect the speed of the cooling fans on the power supply units. Adjusts the brightness of the LCD. Sets the contrast of the LCD screen. Specifies the conditions under which an alert for abnormality is transmitted from the FAULT OUTPUT connector. Red: An alert is transmitted if an error occurs that causes the color indicator to flash red. Y&R: An alert is transmitted if an error occurs that causes the color indicator to light up yellow steadily or flash red. * This EX logo badge is attached on the DSP-RX-EX. The DSP-RX does not feature this badge. UnitMode F/W Ver. Mirr Chk Initialz Toggles between Default mode and Theatre mode. Indicates the current firmware version number of the unit. Verifies whether DSP mirroring is operating properly. This function is available only while two DSP engines are in the mirroring status. Initializes the unit. [ENTER] key Confirms the setting parameter or the value. [6]/[%] keys Enable you to select a setting parameter or value. MY card slots Enable you to install optional Mini-YGDAI cards. [I]/[1] (Power switches A/B) Toggle between power on (I) and off (1). When the power unit is turned on, the indicator lights up. NOTICE • Rapidly turning the unit on and off in succession can cause it to malfunction. After turning the unit off, wait for at least 6 seconds before turning it on again. • Even when the power switches are turned off, a small amount of current is flowing through the unit. If you plan not to use the unit for a long period of time, remove the power cord from the AC outlet. NOTE To maintain power supply redundancy, turn both power switches A and B ON or OFF together. If only one power switch is ON, the LCD will display an error message and the color indicator will light up yellow. DSP-RX(-EX) Owner's Manual 9