Yamaha MCX 1000 Owners Manual - Page 68
Troubleshooting - upgrade
UPC - 027108916811
View all Yamaha MCX 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Troubleshooting Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center. Problem Cause Auto Configuration does not appear to work correctly. The network is not configured correctly. The network signal is weak (for wireless network connections only). Either the MusicCAST server or the MusicCAST client is not set to Auto Configuration mode. The MusicCAST server is storing songs or recording. The MusicCAST client does not output any sound. The volume setting of the MusicCAST client is low. The MusicCAST client is not correctly connected to speakers. You cannot start playback on the MusicCAST client. Auto Configuration is not complete. The network is not configured correctly. The MusicCAST server is turned off. The hard disk drive in the MusicCAST server does not contain any songs that have been completely encoded to MP3 format. When the MusicCAST server is set to distribute MP3 files to your MusicCAST client, the MusicCAST client displays a "*" beside songs which the MusicCAST server has not converted to MP3 format. The network signal is weak (for wireless network connections only). The network signal is weak (for wireless network connections only). Playback from the MusicCAST client skips. The network is extremely congested (for wired network connections only). Remedy Refer to page Check the network settings of the MusicCAST client 21 - 34 and MusicCAST server. Try changing the network channel or the location of the MusicCAST client, or alternatively changing to a wired network connection. 21 - 34 Check the configuration procedure and try again. 21 - 34 Stop recording and start the Auto Configuration process again. Increase the volume setting. MCX1000 owner's manual, page 21 10, 12, 13 Check the connections between the MusicCAST client and the speakers. 11, 20 Run the Auto Configuration process. 26, 27 Check the network settings of the MusicCAST client and MusicCAST server. 21 - 34 Turn the MusicCAST server on. 20 Wait until the MusicCAST server completes encoding songs to MP3. Register songs stored from external components to the library, or wait for the MP3 encoding process to complete. MCX1000 owner's manual, page 121 The "*" displayed beside PCM-only songs disappears when encoding is complete. MCX1000 owner's manual, page 121 Try changing the network channel or the location of the MusicCAST client, or alternatively changing to a wired network connection. 21 - 34 Try changing the network channel or the location of the MusicCAST client, or alternatively changing to a wired network connection. 21 - 34 Place your MusicCAST clients under an independent 21 - 34 subnet mask, or upgrade your network hardware. 105_Musiccast_E.p65 68 68 2003.06.04, 16:09