Yamaha MDX-E300 Owner's Manual - Page 22

EDITING Divide This function lets you divide one track into two separate tracks by adding a new track number to a specified point in the track. Example: Dividing track 3 1 2 3 4 5 6 Before dividing A B C D E 1 2 3 4 5 6 After dividing A B C1 C2 D 1 Play the track you want to divide. 2 Use ! or ⁄ to locate the point where you want to divide the track, then press * to pause at that position. 3 Press EDIT repeatedly to display "Divide ?", then press SET/ENTER. • "Check" appears momentarily, then "Divide OK ?" appears and the MD recorder starts repeating the point where the track will be divided. 4 If necessary, use $ or › to adjust the position of the point where the track will be divided. • The dividing position can be adjusted up to 2 second (255 steps) in either direction. 5 Press SET/ENTER. • The track is divided and "Complete" appears momentarily. Undo The UNDO function lets you immediately return to the condition before an edit is made (note: you cannot undo an edit once you press any other button). 1 Press & to stop the MD recorder. 2 Press EDIT repeatedly to display "Undo ____*1", then press SET/ENTER. • "Undo OK ?" appears in the display. To cancel undoing, press &. : ____*1 The type of editing you can undo is displayed here. 3 Press SET/ENTER again to undo. Note • You cannot undo an edit once it has been written to the TOC. 20 TOC write When making a recording, the TOC (Table Of Contents) of the MD is written as soon as recording is finished. When making disc edits or titling, however, the TOC isn't automatically written unless the disc is ejected. If the unit is accidentally turned off before writing edits or titling to the TOC, it is possible that these changes will not be saved. By using this function, you can ensure that your edits or titles are saved on the disc. 1 Press & to stop playback. 2 Press EDIT repeatedly to display "TOC Write ?", then press SET/ENTER. • "TOC Write OK ?" appears. 3 Press SET/ENTER. • "TOC Writing" blinks in the display momentarily. Note • The TOC Write function can only be selected when the TOC indicator is lit in the display. FRA check When edit functions such as "MOVE" and "DIVIDE" are performed, spaces of recordable space may be lost and "TOC Full" may appear in the display to indicate that no more recording can be performed. When this occurs, it may be possible to recover the FRA (Freely Recordable Area) on the disc that was lost during edit functions so that more recording is possible. 1 Press & to stop playback. 2 Press EDIT repeatedly to display "FRA Check ?", then press SET/ENTER. • "FRA Check OK ?" appears. 3 Press SET/ENTER. • "Complete" appears momentarily.