Yamaha MG10 Owner's Manual - Page 20
Rear SEND Jacks, RETURN L MONO, R Jacks, PHONES Jack, Connector Polarities
View all Yamaha MG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Front & Rear Panels 8 SEND Jacks • AUX1, AUX2 These are impedance balanced phone-type output jacks. These jacks output the signals from AUX1 and AUX2, respectively. You use these jacks, for example, to connect to an effector or monitor system. 9 RETURN L (MONO), R Jacks These are unbalanced phone-type input jacks. The signal received by these jacks is sent to the Stereo bus. These jacks are typically used to receive a return signal from an external effector (reverb, delay, etc.). NOTE These jacks can also be used as an auxiliary stereo input. If you connect to the L(MONO) jack only, the mixer will recognize the signal as monaural and will propagate the identical signal on both L and R jacks. 0 PHONES Jack Connector for headphones. This is a balanced phone-type output jack. Connector Polarities MIC INPUT LINE INPUT (monaural channels), ST OUT, C-R OUT, AUX1, AUX2* INSERT I/O PHONES Pin 1: Ground Pin 2: Hot (+) Pin 3: Cold (-) Tip: Hot (+) Ring: Cold (-) Sleeve: Ground Tip: Output Ring: Input Sleeve: Ground Tip: L Ring: R Sleeve: Ground INPUT OUTPUT Ring Sleeve Tip RETURN, LINE INPUT (stereo channels) Tip: Hot Sleeve: Ground Sleeve Tip * These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced. Rear Section 1 AC ADAPTOR IN Connector Connects to the included PA-10 power adaptor (see page 5). 12 Use only the PA-10 adaptor included with this mixer. Use of a different adaptor may result in fire or electric shock. 2 POWER Switch Use this switch to set mixer power to ON or STANDBY. Note that trace current continues to flow while the switch is in the STANDBY position. If you do not plan to use the mixer again for a long while, be sure to unplug the adaptor from the wall outlet. 20 MG10/2