Yamaha MG8 Owner's Manual - Page 21

Mounting to a Microphone Stand, Turn the mixer right-side up, and mount it onto your - manual

Get Yamaha MG8 PDF manuals and user guides View all Yamaha MG8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Setting Up Mounting to a Microphone Stand • When using the mixer on a microphone stand, be sure to set the stand on a level and stable surface. Do not set up the stand in locations subject to vibrations or wind. • Note that mixer may be damaged if the stand should fall over. Attach the connection cables carefully so that the cables will not catch on the equipment and cause it to fall. For example: arrange the cables so that they run parallel with the microphone pole down to the base of the stand. • Leave ample free space around the stand. 1 Turn the mixer upside-down, and hold the microphone-stand adaptor (BMS-10A; sold separately) against the bottom of the mixer so that the screw holes are aligned (1). Screw the adaptor firmly into place with the two screws (2). 3 Loosen the angle adjustment wingnut (1), adjust the mixer's angle as desired (2), and then tighten the wingnut securely (3). 2 3 1 For more information, refer to the BMS-10A Owner's Manual. 2 1 2 Turn the mixer right-side up, and mount it onto your microphone stand. MG8/2FX 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Setting Up
MG8/2FX
21
Mounting to a Microphone Stand
•
When using the mixer on a microphone stand, be
sure to set the stand on a level and stable surface.
Do not set up the stand in locations subject to
vibrations or wind.
•
Note that mixer may be damaged if the stand
should fall over. Attach the connection cables
carefully so that the cables will not catch on the
equipment and cause it to fall. For example:
arrange the cables so that they run parallel with
the microphone pole down to the base of the
stand.
•
Leave ample free space around the stand.
Turn the mixer upside-down, and hold the micro-
phone-stand adaptor (BMS-10A; sold separately)
against the bottom of the mixer so that the screw holes
are aligned (
1
).
Screw the adaptor firmly into place with the two
screws (
2
).
Turn the mixer right-side up, and mount it onto your
microphone stand.
Loosen the angle adjustment wingnut (
1
), adjust the
mixer’s angle as desired (
2
), and then tighten the
wingnut securely (
3
).
For more information, refer to the BMS-10A Owner’s Man-
ual.
1
1
2
2
3
1
3
2