Yamaha MG8 Owner's Manual - Page 22

Appendix Appendix Specifications ■ Electrical Characteristics Conditions MIN Total Harmonic Distortion (MIC to ST OUT) (THD+N) 20 Hz - 20 kHz @+14dBu 10k ohms (CH1, 2) with Signal input CH LEVEL Control and ST Master LEVEL Control at nominal level Frequency Response (MIC to ST OUT) 20 Hz - 20 kHz @+4 dBu 10k ohms with GAIN control at minimum level -3 Equivalent Input Noise (CH1, 2) Hum & Noise (20 Hz - 20 kHz) Rs=150 ohms, Gain=Maximum, Sensitivity=-60 dBu, Hum & Noise are measured with a -6 dB/octave filter @12.7 kHz;equivalent to a 20 kHz filter with infinite dB/octave attenuation. Residual Output Noise (ST OUT) ST Master Control at nominal level and all CH LEVEL Control at minimum level. (ST OUT) All CH EFFECT Control at minimum level and all CH LEVEL at minimum level. (EFFECT SEND) ST Master Control and one CH LEVEL Control at nominal level. (CH1, 2) (ST OUT) CH MIC INPUT to CH INSERT OUT CH MIC INPUT to ST OUT CH MIC INPUT to REC OUT Maximum Voltage Gain CH MIC INPUT to EFFECT SEND ST CH MIC INPUT to ST OUT PAN/BAL : panned hard left or hard right. ST CH LINE INPUT to ST OUT ST CH LINE INPUT to EFFECT SEND ST CH INPUT to ST OUT RETURN to ST OUT 2TR INPUT to ST OUT Crosstalk (1 kHz) Adjacent inputs input to output Monaural/Stereo Input GAIN Control variable range Where 0 dBu = 0.775 V TYP MAX UNIT 0.1 % 0 1 dB -128 dBu -100 dBu -87 (91 dB S/N) dBu -85 (89 dB S/N) dBu -64 (68 dB S/N) dBu 60 dB 76 dB 64.2 dB 70 dB 76 dB 50 dB 41 dB 26 dB 12 dB 23.8 dB -70 dB -70 dB 44 dB ■ General Specifications Monaural/Stereo CH High Pass Filter Monaural/Stereo CH Equalization Turn over /roll-off frequency of shelving, 3 dB below maximum variable level Internal Digital Effect Phantom Power Monaural/Stereo Input PEAK Indicator Level Meters Included Accessories Options Power Consumption Dimensions (W × H × D) Weight Where 0 dBu = 0.775 V 80 Hz 12 dB/octave ±15 dB (Max. Variation) HIGH: 10 kHz (shelving) MID: 2.5 kHz (peaking) LOW: 100 Hz (shelving) 16 programs, Parameter control FOOT switch (ON/OFF) Supplied when Phantom +48 V switch is ON. (XLR-type input jacks) On each channel: red indicator lights if post-EQ signal (on ST channels, if either post-EQ signal or post-mic-amp signal) comes within 3 dB of the clipping level. Two 12-points LED level meters [ST (L, R)] Peak point: red indicator +5, +3, +1, 0: yellow indicators -1, -3, -5, -7, -10, -15, -20: green indicators Power adaptor (PA-10) Microphone-stand adaptor (BMS-10A), Footswitch (FC5) 25 W 251 mm × 65 mm × 290.5 mm 1.8 kg 22 MG8/2FX