Yamaha MSP10M Owner's Manual - Page 4

Front panel/Rear panel 1 2 34 5 +4dB -2 -1 0 LOW -1 0 +1 HIGH TRIM ON OFF (80Hz) LOW CUT MIN -6dB SENSITIVITY INPUT 1 Power/Clip indicator This indicator lights up green when you turn the POWER switch on the rear panel ON. If the output level is too high, causing clipping at the amplifier, the indicator lights up red. In this case, lower the input level. ON OFF POWER 6 2 TRIM switches These switches enable you to adjust the bass and treble for the MSP10/10M. LOW: three positions The LOW switch adjusts the bass range. With the "-1" and "-2" settings, the bass range is cut by 1.5 dB when based on a reference value of 50 Hz with the "0" setting. HIGH: three positions The HIGH switch adjusts the treble. With the "+1" setting, the treble range is boosted by 1.5 dB when based on a reference value of 10 kHz with the "0" setting. With "-1" setting, the treble range is cut by 1.5 dB. 3 LOW CUT switch This switch turns on or off the high-pass filter that cuts frequency ranges below 80 Hz. 4 SENSITIVITY control Adjust the volume according to the output sensitivity of the connected device. (The factory default setting is "MIN.") 5 INPUT jack This is an XLR-type balanced input jack. 6 POWER switch This switch turns the power to the MSP10/10M on and off. When you turn this switch on, the power/ clip indicator lights up green. 5