Yamaha N-100 Owner's Manual - Page 28
Fix B to A., Do not insert the feet of the groove cover between
View all Yamaha N-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
ENGLISH Keyboard Stand Assembly 2-3 While supporting B with your hand, pass the pedal cord (attached to C) through from the inside to the outside of B. Position C upside down, then insert it into the slot on B. Be sure to push C until it stops. 2-7 Replace the plastic cover onto the groove of B. Do not insert the feet of the groove cover between the groove socket and groove wall. B C B 2-4 While holding and pressing C securely into the slot, fix it to B using four long screws (6x20mm). B Correct Incorrect 3. Fix B to A. 3-1 Place B in front of A, with the speaker net on B facing upward. 3-2 Insert the speaker cord plug into the connector on the bottom surface of A, with the plug's tab facing to the rear. C B 2-5 Turn B so that its bottom side of (the side on which C is attached) is on the floor. 2-6 Pass the pedal cord and power cord into the groove on B, then attach them to the top of B using the four vinyl ties. Be sure to have the end of the power cord extend past the top edge of B by 20cm or more (roughly half the length of B). At least 20cm A B 20cm B 28 N-100 Owner's Manual