Yamaha RX-395RDS Owner's Manual - Page 15

English TO RECORD A SOURCE TO TAPE 1, 4 2 RX-495RDS 1 Select the source to be recorded. RX-395, RX-395RDS 1 Select the source to be recorded. TUNER CD MONITOR TAPE 2 TAPE 1 AUX PHONO COPY * To dub from tape to tape, refer to the "Notes" shown below. * When you select AUX, TUNER, CD or PHONO, make sure that neither TAPE 1 nor TAPE 2 is also selected. 2 Play the source and then turn the VOLUME control up to confirm the input source. (For detailed information on the tuning operations, refer to the page 17.) 3 Begin recording on the tape deck. 4 To monitor the audio signals being recorded, press the input selector button for the tape deck being used to make the recording. TUNER CD MONITOR TAPE 2 TAPE 1 AUX PHONO COPY Notes q VOLUME, BASS, TREBLE, BALANCE, LOUDNESS controls and PURE DIRECT switch settings have no effect on the material being recorded. q To dub from tape to tape, select TAPE 2 by pressing it. Only the following method of dubbing can be made by using this unit. SOURCE RECORDER Tape deck connected to the TAPE 2 terminals. → Tape deck connected to the TAPE 1 terminals. TUNER CD TAPE MONITOR AUX PHONO * When you select AUX, TUNER, CD or PHONO, make sure that TAPE MONITOR is not also selected. 2 Play the source and then turn the VOLUME control up to confirm the input source. (For detailed information on the tuning operations, refer to the page 17.) 3 Begin recording on the tape deck. 4 To monitor the audio signals being recorded, press the TAPE MONITOR. TUNER CD TAPE MONITOR AUX PHONO Note VOLUME, BASS, TREBLE, BALANCE and LOUDNESS control settings have no effect on the material being recorded. 15