Yamaha RX-395RDS Owner's Manual - Page 7
English, A/B/C/D/E button - rx receiver
View all Yamaha RX-395RDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English 1 POWER switch Press this switch to switch the power on. Press it again to switch the power off. * Standby mode While the power is on, pressing the POWER key on the remote control transmitter switches the unit to the standby mode. (In this mode, the power indicator is half illuminated.) 2 Power indicator Lights up while the power is on. 3 Remote control sensor Receives signals from the remote control transmitter. 4 RDS MODE/FREQ button RX-495RDS and RX-395RDS only When an RDS station is received, pressing this button changes the display mode into the PS mode, PTY mode, RT mode and/or CT mode (if the station employs those RDS data services), and frequency display in turn. 5 Display panel Shows station frequencies and various information. (Refer to the next page for details.) 6 FM/AM buttons Press this button to switch the reception band to FM or AM. 7 TUNING DOWN/UP button Used for tuning. Press the "UP" side to tune in to higher frequencies, and press the "DOWN" side to tune in to lower frequencies. 8 EDIT button This button is used to exchange the places of two preset stations with each other. 9 MEMORY (MAN'L/AUTO FM) button When this button is pressed, the MEMO(RY) indicator flashes for about 5 seconds. During this period, press the desired PRESET STATIONS button to enter the displayed station into the memory. When this button is pressed and holded for about 3 seconds, the automatic preset tuning begins. 0 Input selector buttons Select a program source to listen to. When a button is pressed, the name of selected source lights up on the display. A PURE DIRECT switch RX-495RDS only Press this switch to listen to a source in the purest sound. (Refer to page 16 for details.) B PHONES jack When you listen with headphones, connect the headphones to the PHONES jack. When listening with headphones privately, set both the SPEAKERS A and B switches to the OFF position. PHONES C SPEAKERS switches Set the switch A or B (or both A and B) for the speaker system (connected to this unit) you will use to the ON position. Set the switch for the speaker system you will not use to the OFF position. D PTY SEEK MODE button RX-495RDS and RX-395RDS only When this button is pressed, the unit turns into the PTY SEEK mode. E PTY SEEK START button RX-495RDS and RX-395RDS only Press this button to begin searching for a station after the desired program type is selected in the PTY SEEK mode. F EON button RX-495RDS and RX-395RDS only Press this button to select a desired program type (NEWS, INFO, AFFAIRS, SPORT) when you want to call a radio program of that program type automatically. G TUNING MODE (AUTO/MAN'L) button Press this button to switch the tuning mode to automatic or manual. To select the automatic tuning mode, press this button so that "AUTO (TUNING)" lights up on the display. To select the manual tuning mode, press this button so that "AUTO (TUNING)" goes off. H Tone controls BASS Used to increase or decrease the low frequency response. The 0 position produces flat response. TREBLE Used to increase or decrease the high frequency response. The 0 position produces flat response. I BALANCE control Adjusts the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions. J A/B/C/D/E button Press this button to select a desired group (A-E) of preset stations. K PRESET STATIONS buttons Used to enter as many as 40 station frequencies into the memory. L Continuously variable LOUDNESS control Used to compensate for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. M VOLUME control Used to raise or lower the volume level. 7