Yamaha WXC-50 WXC-50 Owner s Manual Advanced - Page 35
Access device Indication, Max Volume
View all Yamaha WXC-50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
SETTINGS (Menu) Volume Item L/R Balance Mode Initial Volume Level Max Volume Subwoofer Volume Input Trim Input Setting Auto Play User Interface Bluetooth Front Panel Operation Sensor Remote ID LED Dimmer Access device Indication Bluetooth Standby Audio Receive Private Mode Settings -12 to 0 to +12 (steps of 1) Off / On Mute, -80 dB to +0.0 dB (0.5 dB steps) -20 dB to +0.0 dB (0.5 dB steps) -6.0 to 0.0 to +6.0 dB (0.5 dB steps) -6.0 to 0.0 to +6.0 dB (0.5 dB steps) Off / On / Auto Off / On Off / On ID1 / ID2 0-3 - Off / On Off / On Off / On Default 0 Off -40.0 dB 0.0 dB 0.0 dB Explanation Adjusts the balance of the volume between the left and right speakers. Enables/disables setting of the initial volume when the unit is turned on. Sets the initial volume for when the unit is turned on. Sets an upper limit for the volume levels to which the unit can be adjusted using the remote control, etc. Makes fine adjustments to the volume of the subwoofer. 0.0 dB Compensates for volume differences between input sources. different for every input source On On ID1 3 On On Off Sets whether or not audio is automatically played back from servers, USB devices, etc. when the unit is turned on or the input source is switched. "Off": always starts up with playback stopped. "On": always begins playing back the content that was played the previous time. "Auto": begins playback if audio was currently being played back when the unit was turned to standby. Note The setting value is different for every input source or service. Enables/disables operation using the front panel (other than the power key). Enables/disables operation using the remote control. When this is "Off", the unit can still be operated by other means. Changes the ID of the remote control from which the unit receives signals. To change the ID of the remote control, set it as follows. Set to ID1: on the remote control, hold down f and PRESET 1 at the same time for 5 seconds. Set to ID2: on the remote control, hold down f and PRESET 2 at the same time for 5 seconds. Adjusts the brightness of the LED ("3" is the brightest). Lights the LED of the device currently being used for operation via a web browser. Enables/disables the Bluetooth function. Enables/disables the feature allowing the unit to be turned on by Bluetooth devices (Bluetooth Standby). Sets whether or not the unit responds to searches other than from the paired Bluetooth device. When this is "On", the unit does not respond to searches. 35 En