Yamaha YAS-152 Owners Manual - Page 15
Controlling the TV via the sound bar (when the TV’s remote control sensor is blocked)
View all Yamaha YAS-152 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Controlling the TV via the sound bar (when the TV's remote control sensor is blocked) When the TV Remote Repeater function is enabled, the sound bar receives TV remote control signals at the TV remote control sensor (on front) and transmits the signals from the TV Remote Repeater (on rear). This function is useful when you cannot operate your TV from the remote control because the remote control sensor of the TV is blocked by the sound bar. NOTE • This function is available only when your TV remote control uses infrared signals. TV Remote Repeater TV's remote control sensor TV remote control 1 Turn on the sound bar. 2 Hold down the REPEATER key on the supplied remote control for more than 3 seconds to enable/disable the TV Remote Repeater function. Flash 3 times (enabled), Flash once (disabled) This completes the necessary settings. When the TV Remote Repeater function is enabled, you can operate your TV from the TV remote control via the sound bar. HINT • The TV Remote Repeater function is disabled by default. • If the power cable of the sound bar is connected to an AC wall outlet and when the TV Remote Repeater function is enabled, the function is usable even when the sound bar is turned off. • If you have made the sound bar learn the volume (+) operation (p.12), the volume of the TV may be turned up when you turn up the volume of the sound bar with the TV remote control. In this case, follow Step 3 in "Connections" (p.5) to change the TV setting. • You can check the status of the TV Remote Repeater function by the center indicator when turning on the sound bar. Off (enabled), lights up (disabled) Using an external subwoofer The sound bar has dual built-in subwoofers; however, you can connect an external subwoofer. Perform the following steps to change the setting when using an external subwoofer. 1 Connect the sound bar to the external subwoofer with a pin cable. Mono input 2 With the sound bar turned off, hold down the SUBWOOFER (-) key on the supplied remote control for more than 5 seconds. The sound bar turns on and the external subwoofer is selected. You can check the status of the subwoofer setting by the ANALOG indicator when turning on the sound bar. Off (external subwoofer), lights up (built-in subwoofer) To select the built-in subwoofers again, hold down the SUBWOOFER (+) key of the remote control for more than 5 seconds. NOTE • The default output setting is for the built-in subwoofers. • The built-in subwoofer and external subwoofer cannot be used simultaneously. • Use an external subwoofer with built-in amplifier. En 13