Yamaha YAS-152 Owners Manual - Page 18
Remote control, The TV cannot
View all Yamaha YAS-152 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Remote control Problem The sound bar cannot be controlled using the remote control. The TV cannot be controlled using the TV remote control. The TV cannot be controlled by using the TV Remote Repeater function. Cause The sound bar is out of the operating range. The batteries are weak. The remote control sensor of the sound bar is exposed to direct sunlight or strong lighting. The remote control sensor of the TV is blocked by the sound bar. There may be any problem with the TV or TV remote control. The TV Remote Repeater function is disabled. The TV remote control does not use infrared signals. (Some remote controls may not work even if it uses infrared signals.) The sound bar and TV are too close or too far from one another. There is any obstacle (such as cables) between the sound bar and TV. Remedy Use the remote control within the operating range (p.6). Replace with new batteries (p.6). Adjust the lighting angle, or reposition the sound bar. Use the TV Remote Repeater function (p.13) or remove the stands of the sound bar so that the TV remote control sensor is not blocked (p.4). Refer to the manuals of the TV. Enable the TV Remote Repeater function (p.13). The TV Remote Repeater function cannot be used in this case. Adjust the position of the sound bar so that the remote control sensor of the TV is not blocked by the sound bar and use the TV remote control to operate the TV. Move the sound bar away from the TV more than 50 mm (2") (p.4). If necessary, remove or attach the stands of the sound bar (p.4). Remove the obstacle between the sound bar and TV. The sound bar does not learn TV remote control operations. Sound is coming from the TV when the sound bar volume is turned up with the TV remote control. (when TV remote control learning function is used) The power of the sound bar and of the TV switch in the opposite direction. (For example, the TV is turned off if the sound bar is turned on.) (when TV remote control learning function is used) The TV remote control key was not held down long enough. The TV remote control does not use infrared signals. (Some remote controls may not work even if it uses infrared signals.) The position where you operated the TV remote control is not appropriate. The batteries of the TV remote control are weak. The remote control sensor of the sound bar is exposed to direct sunlight or strong lighting. The transmission of the remote control signal was disturbed by the TV screen light. Audio output is enabled on the TV. The power of the TV was on when you performed the learning operation. Hold down the key for more than 1 second twice or three times (p.11). The TV remote control learning function cannot be used in this case. Use the supplied remote control to operate the sound bar. Operate the TV remote control at the appropriate position (p.11). Replace with new batteries. Adjust the lighting angle, or reposition the sound bar. Turn off the TV and perform the learning operation again (p.11). Change the TV setting to disable the TV speaker output. If a setting to disable the speaker output is not available on your TV, try the following methods. - Connect headphones to the headphone jack on the TV. - Set the TV volume to minimum. Press the power key on the TV and (power) on the front panel of the sound bar to turn on them and then press the power key on the TV remote control to turn off them. 16 En