Yamaha YDP-163 YDP-163_143 Owners Manual - Page 30
Keyboard Stand Assembly
View all Yamaha YDP-163 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Keyboard Stand Assembly The illustrations here are taken from the YDP-143. CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please assemble the unit in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Assemble the unit on a hard and flat floor with ample space. • Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Use of incorrect screws can cause damage or malfunction of the product. • Be sure to tighten all screws upon completing assembly of the unit. • To disassemble, reverse the assembly sequence given below. 1. After untying the bundled pedal cord on C, attach C to D and E and fasten the screws (1-3). E 1-2 Have a Phillips-head (+) screwdriver of the appropriate size ready. D C Remove all parts from the package and make sure you have all of the items. Cord holder A D E B C Bundled pedal cord inside AC adaptor (YDP-163) Power cord (YDP-163) AC adaptor (YDP-143) * The adaptor may not be included, or may look different from the illustration above, depending on your particular area. Please check with your Yamaha dealer. Screws set 6 x 20 mm long screws x 4 4 x 12 mm thin screws x 2 1-3 1-1 1-1 Untie and straighten out the bundled pedal cord. Untie the two vinyl strings. C 1-2 Align D and E with each end of C. 1-3 Attach D and E to C by finger-tightening the long screws (6 x 20 mm). 6 x 16 mm short screws x 4 4 x 20 mm tapping screws x 4 Headphone hanger set (YDP-163 only) 4×10 mm thin screws Headphone hanger 30 YDP-163/YDP-143 Owner's Manual