Yamaha YDP-163 YDP-163_143 Owners Manual - Page 31
Attach B., Secure C., Mount A., Secure
View all Yamaha YDP-163 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Keyboard Stand Assembly 2. Attach B. Depending on the model of digital piano you purchased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color similar to D and E faces the player. 2-1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2-2 Attach the top of B to D and E by finger- tightening the thin screws (4 x 12 mm). 2-3 While pressing on the lower part of D and E from the outside, secure the bottom ends of B using two tapping screws (4 x 20 mm). 2-4 Insert the other two tapping screws (4 x 20 mm) into the other two screw holes to secure B. 2-5 Securely tighten the screws on the top of B that were attached in Step 2-2. 2-2, 2-5 E B 2-3 D 2-1 Place the bottom ends 2-4 of the rear panel on each foot. 2-3 3. Secure C. Securely tighten the screws on C that were attached in Step 1-3. 4. Mount A. Be sure to place your hands at least 10 cm from either end of A when positioning it. At least 10 cm A E At least 10 cm B D CAUTION • Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit. • Do not hold the keyboard in any position other than the position shown in the illustration. 5. Secure A. 5-1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 5-2 Secure A by tightening the short screws (6 x 16 mm) from the front. 5-1 Projection of A B C 3 5-2 31 YDP-163/YDP-143 Owner's Manual