Zanussi ZWI71201WA Product Manaul - Page 23
U piece supplied
View all Zanussi ZWI71201WA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Read carefully the instructions supplied with the kit. Water inlet Caution! • This appliance must be connected to a cold water supply. • Before connecting up the appliance to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected. • Do not use the hose from your previous appliance to connect to water supply. The inlet hose is supplied with the appliance and can be found inside the machine drum. 35° 45° a new, longer hose specially designed for this type of use. Warning! Installation should comply with local water authority and building regulations' requirements. The appliance must be connected to a cold water supply. A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance. If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance's inlet and the bottom of the water storage tank. Water drainage This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. Open the porthole and extract the inlet hose. Connect the appropriate end of the hose to the appliance with the angled connection as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks . Connect the other end of the inlet hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance. Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase Firstly form a hook in the end of the drain hose using the "U" piece" supplied. "U" piece supplied Place the drain hose into your standpipe, which should have an internal diameter of approximately 38 mm thus ensuring there is an air break between the drain hose and standpipe. When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level. www.zanussi.com 23