Zenith SL-4132-MW User Guide - Page 2

Mode Switching Summary TEST ON-TIME Switch at 1, 5, or 10 minutes AUTO Flip light switch MANUAL MODE off for one second then back on* * If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode. Wire Path 4. Attach mounting plate to junction box. Ground Screw INSTALLATION For best performance, mount the fixture about 6 feet (1.8 m) above the ground. WARNING: Turn power off at circuit breaker or fuse. 1. Remove two nuts. 2. Remove Mounting Plate. 3. Tighten screws finger tight. This fixture comes with a universal mounting bracket. It is pre-assembled on the fixture to fit the majority of junction box applications. However, if the slots on the mounting plate do not line up with the junction box screw holes: 1. Remove the fixture mounting screws from the mounting plate. Note: Do not remove the ground screw. 2. Attach ground wire "pigtail" to ground screw on mounting plate (See Recommended Grounding Method for additional information). 3. Flip the mounting plate over.  595-5530-13