Zenith XBV443 Operating Guide - Page 35
Troubleshooting
UPC - 044642701376
View all Zenith XBV443 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Troubleshooting Check the following guide for the possible cause of a problem before contacting service. REFERENCE Symptom No power. Cause The power cord is disconnected. The power is on, but the DVD+VCR does not work. No picture. No disc is inserted. No tape is inserted. The TV is not set to receive DVD+VCR signal output. TV/VCR mode for DVD+VCR is set to TV. No sound. The video cable is not connected securely. The connected TV power is turned off. The equipment connected with the audio cable is not set to receive DVD+VCR signal output. The audio cables are not connected securely. The power of the equipment connected with the audio cables is turned off. The Digital Audio Output is set to the wrong position. The playback picture is poor. The DVD+VCR does not start playback. The disc is dirty. Tape heads are dirty. Tape is a rental or was recorded on another VCR. No disc is inserted. No tape is inserted. An unplayable disc is inserted. The disc is placed upside down. The disc is not placed within the guide. The disc is dirty. The Rating level is set. The remote control does not work properly. The remote control is not pointed at the remote sensor of the DVD+VCR. The remote control is too far from the DVD+VCR. There is an obstacle in the path of the remote control and the DVD+VCR. The batteries in the remote control are dead. This remote control uses the same buttons for VCR and DVD functions (ex. PLAY). Correction Plug the power cord into the wall outlet securely. Insert a disc or tape. (Check that the disc or tape indicator in the display window is lit.) Select the appropriate video input mode on the TV so the picture from the DVD+VCR appears on the TV screen. Press the TV/VCR button on the remote control repeatedly to choose VCR mode. TV indicator disappears from the display window. Connect the video cable securely. Turn on the TV. Select the correct input mode on the audio receiver so you can listen to the sound from the DVD+VCR. Connect the audio cables securely. Turn on the equipment connected with the audio cables. Set the Digital Audio Output to the correct position, then turn on the DVD+VCR again by pressing POWER. Clean the disc. Clean video heads. Use CH/TRK (v/V) for manual tracking adjustment while tape is playing. Insert a disc or tape. (Check that the disc or tape indicator in the display window is lit.) Insert a playable disc. (Check the disc type, color system, and Regional code.) Place the disc with the playback side down. Place the disc on the disc tray correctly inside the guide. Clean the disc. Cancel the Rating function or change the rating level. Point the remote control at the remote sensor of the DVD+VCR. Operate the remote control within 23 ft (7 m). Remove the obstacle. Replace the batteries with new ones. When using a VCR, first press the VCR button. When using a DVD, first press the DVD button. 35