ZyXEL NBG4615 v2 User Guide - Page 180
Add/Edit Static Route
View all ZyXEL NBG4615 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
Chapter 20 Static Route Figure 115 Network > Static Route The following table describes the labels in this screen. Table 74 Network > Static Route LABEL DESCRIPTION Add Static Route Click this to create a new rule. # This is the number of an individual static route. Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb). Name This field displays a name to identify this rule. Destination Gateway This parameter specifies the IP network address of the final destination. Routing is always based on network number. This is the IP address of the gateway. The gateway is a router or switch on the same network segment as the device's LAN or WAN port. The gateway helps forward packets to their destinations. Subent Mask This parameter specifies the IP network subnet mask of the final destination. Modify Click the Edit icon to open a screen where you can modify an existing rule. Click the Delete icon to remove a rule from the NBG4615 v2. Apply Click Apply to save your changes back to the NBG4615 v2. Cancel Click Cancel to begin configuring this screen afresh. 20.2.1 Add/Edit Static Route Click the Add Static Route button or a rule's Edit icon in the Static Route screen. Use this screen to configure the required information for a static route. Figure 116 Network > Static Route: Add/Edit 180 NBG4615 v2 User's Guide