ZyXEL P-2812HNU-51c User Guide - Page 98
Table 8, Label, Description
View all ZyXEL P-2812HNU-51c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Chapter 5 Broadband Table 8 Broadband Add/Edit: Routing- IPoE (VDSL/EtherWAN) (continued) LABEL DESCRIPTION WAN Service Type This field is available only when you select Routing in the Mode field. Select the method of encapsulation used by your ISP. IPv6/IPv4 DualStack VLAN • PPP over Ethernet (PPPoE) - PPPoE (Point to Point Protocol over Ethernet) provides access control and billing functionality in a manner similar to dial-up services using PPP. Select this if you have a username and password for Internet access. • IP over Ethernet - In this type of Internet connection, IP packets are routed between the Ethernet interface and the WAN interface and then formatted so that they can be understood in a bridged environment. Select Enable to allow the Device to run IPv4 and IPv6 at the same time. If this function is disabled, the Device only runs IPv4. This section is available only when you select VDSL or EtherWAN in the Type field. Enable VLAN Enter 802.1P Priority Select this to add the VLAN tag (specified below) to the outgoing traffic through this connection. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. Enter 802.1Q VLAN Type the VLAN ID number (from 1 to 4094) for traffic through this connection. ID IP Address This section is available only when you select Routing in the Mode field and IPoE in the WAN Service Type field. Obtain an IP Address Automatically A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different one each time you connect to the Internet. Select this if you have a dynamic IP address. Enable DHCP Option 60 Vendor Class Identifier Static IP Address Select this to identify the vendor and functionality of the Device in DHCP requests that the Device sends to a DHCP server when getting a WAN IP address. Enter the Vendor Class Identifier (Option 60), such as the type of the hardware or firmware. Select this option If the ISP assigned a fixed IP address. IP Address Subnet Mask Gateway IP Address Enter the static IP address provided by your ISP. Enter the subnet mask provided by your ISP. Enter the gateway IP address provided by your ISP. Routing Feature NAT Enable Select this option to activate NAT on this connection. IGMP Proxy Enable Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish membership in a Multicast group - it is not used to carry user data. Apply as Default Gateway Select this option to have the Device act as an IGMP proxy on this connection. This allows the Device to get subscribing information and maintain a joined member list for each multicast group. It can reduce multicast traffic significantly. Select this option to have the Device use the WAN interface of this connection as the system default gateway. DNS Server This is available only when you select Apply as Default Gateway in the Routing Feature field. Obtain DNS info Automatically Select this to have the Device get the DNS server addresses from the ISP automatically. 98 P-2812HNU(L)-Fx Series User's Guide