2005 Buick LaCrosse Owner's Manual - Page 319

To disconnect the jumper cables from both vehicles, do the following: 1. Disconnect the black negative (−) cable from the vehicle that had the dead battery. 2. Disconnect the black negative (−) cable from the vehicle with the good battery. 3. Disconnect the red positive (+) cable from the vehicle with the good battery. 4. Disconnect the red positive (+) cable from the other vehicle. 5. Return the fuse block cover to its original position. The vehicle should be properly prepared as follows: • The vehicle should be placed so the headlamps are 25 ft. (7.6 m) from a light colored wall or other flat surface. • The vehicle must have all four tires on a perfectly level surface which is level all the way to the wall or other flat surface. • The vehicle should be placed so it is perpendicular to the wall or other flat surface. • The vehicle should not have any snow, ice or mud on it. Headlamp Aiming The vehicle has a visual optical headlamp aiming system. The aim has been preset at the factory and should need no further adjustment However, If the vehicle is damaged in an accident, the headlamp aim may be affected and adjustment may be necessary. If oncoming vehicles flash their high beams at you, this may also mean the vertical aim needs to be adjusted. It is recommended that the vehicle is taken to your dealer for service if the headlamps need to be re-aimed. It is possible however, to re-aim the headlamps as described in the following procedure. • The vehicle should be fully assembled and all other work stopped while headlamp aiming is being done. • The vehicle should be normally loaded with a full tank of fuel and one person or 160 lbs (75 kg) on the driver's seat. • Tires should be properly inflated. Headlamp aiming is done with the vehicle's low-beam headlamps. The high-beam headlamps will be correctly aimed if the low-beam headlamps are aimed properly. The vertical headlamp aiming screws are located under the hood near the headlamps. 5-43