2013 Buick Enclave Owner Manual - Page 280

10-18 Vehicle Care When to Check Power Steering Fluid It is not necessary to regularly check power steering fluid unless you suspect there is a leak in the system or you hear an unusual noise. A fluid loss in this system could indicate a problem. Have the system inspected and repaired. The fluid level should be somewhere between the MAX and MIN line on the dipstick in room temperature. If the fluid is on or below the MIN line, add fluid close to the MAX Line. Notice: After driving in the overheated engine protection operating mode, to avoid engine damage, allow the engine to cool before attempting any repair. The engine oil will be severely degraded. Repair the cause of coolant loss, change the oil and reset the oil life system. See Engine Oil on page 10‑7. What to Use To determine what kind of fluid to use, see Recommended Fluids and Lubricants on page 11‑12. Always use the proper fluid. Notice: Use of the incorrect fluid may damage the vehicle and the damages may not be covered by the vehicle's warranty. Always use the correct fluid listed in Recommended Fluids and Lubricants on page 11‑12. Power Steering Fluid How to Check Power Steering Fluid To check the power steering fluid: 1. Turn the key off and let the engine compartment cool down. 2. Remove the engine cover. See Engine Cover on page 10‑6. The power steering fluid reservoir is located under the engine cover on the passenger side of the vehicle. See Engine Compartment Overview on page 10‑5 for reservoir location. 3. Wipe the cap and the top of the reservoir clean. 4. Unscrew the cap and wipe the dipstick with a clean rag. 5. Replace the cap and completely tighten it. 6. Remove the cap again and look at the fluid level on the dipstick. Washer Fluid What to Use When adding windshield washer fluid, be sure to read the manufacturer's instructions before use. If the vehicle will be operating in an area where the temperature