1997 Cadillac DeVille Owner's Manual - Page 74

or unlock buttons on the RKE transmitter are pressed. Press the TRIP SET (TRIP RESET) button to answer "yes," press the RESET (INFO RESET) button to indicate "no" or press the INFORMATION (INFO) button to Note that pressing the transmitter buttons numerous times "skip" to the next personalization feature. To begin programming, the ignition must be the RUN in (approximately 500 times) out of the vehicle's operating range may cause the transmitter not to work. Replacing position. Press and hold the INFORMATION (INFO) and RESET (INFO RESET) buttons at the same time. the battery and pressing the transmitter buttons or 10 The first message to appear refers to programmable the more times out range will also cause transmitter of the not to work.To reset the transmitter, you must be within automatic door locks. To skip this prompt, pressthe INFORMATION (INFO) button. the vehicle's operating range. Press and hold the trunk button, and within one second, press and hold the lock When REMOTE FLASH LIGHTS appearson the DIC button. Continue to hold both buttons approximately for display, press the yes button program the parking to three seconds. See your Cadillac dealer service if your for lamps to blink once when the lock button on theRKE transmitter still doesn't work properly. transmitter is pressed and to blink when the twice The RKE transmittercan also be used to recall the memory settings for up to two drivers. For more information, see "Memory Seat and Mirrors" in the Index. RKE Personalization Features Remote Confiimation (If Equipped) Before you select features, be sure that the number on the back of the RKE transmitter matches the driver preferred. You can confirm the correct driver by placing the keyin the LOCK position and pressing unlock on the RKE transmitter. This personalization feature allows the driver to program the parking lamps to blink or to remain when the lock off unlock button is pressed. you don't wantthe parking If lamps to blink when using the RKE transmitter, press the no button. FEATURE ON will displayif REMOTE FLASH LIGHTS was selected and FEATURE will show if OFF you answer no. For a list of the other personalization features available, see "Memory and Personalization Features" later in this section.