1997 Cadillac Eldorado Owner's Manual - Page 175

Br: Press the left m o w to reverse the tape rapidly. Press it again to return to playing speed. The radio will play while the tapereverses and REV will appear on the display. You may use your station pushbuttons to tune to another radio station while in REV mode. FF: Press the right arrow to fast forward to another part of the tape. Press it again to return to playing speed. The radio will play whilethe tape advances andFF will appear on the display. You may ~ l s e your station pushbuttons to tune to another radio station while in mode. SOURCE: Press this buttonto switch from radio to cassette tape play. If no cassette tapeis in the tape player, CASS appears on the display and then the radio station appears briefly. The display then revertsback to showing the time of day. Press this button again or BAND to switch back to the radio. A EJECT: Press the upward triangle button to remove a tape. The radio will play. Eject may be activated with the radiooff if the ignition is on. Cassette tapes may be loaded with the radio but they willnot start playing off until the PWR button is pressed. Press PWR or turn the ignition key off to stop the cassette tape player. The tape will stay inthe player and resume play atthe point where it stopped. If you leave a cassette tape in the player while listening to the radio, it may become w m . SEEK-TUNE: Press the right arrow to seek to the next selection on the tape. Press the left arrow to search for the previous selection on the tape (REP will appear on the display). Your tape must have at least threeseconds of silence between each selection for SEEM-TUNE to work. The sound willmute while seeking. SCAN: Press this button. SCAN FF will appear on the display until the nextselection is found and thenSCAN PLAY will appear on the display. Use SCAN to listen to selections for a few seconds. The tape will go to a selection, stop for a few seconds, then go on to the next selection. Press this button again stop scanning. to SIDE: Press this button to change the side of the tape that is playing. (PLAY shows on the display.) CLN: If this message appearson the display, the be cassette tape player needs to cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damage to the tapes and player.See "Care of Your Cassette Tape Player"in the Index. After you clean the player, pressand hold EJECT h r five seconds to reset the CLN indicator. Theradio will display --- to show the indicator was reset. Dolby@Noise Reduction is manufactured undera license from Dolby LaboratoriesLicensing Corporation. Dolby and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.